Williams 0743511, 0743512 installation instructions Direct-VentWall Furnace

Page 1
Installation Instructions and Owner’s Manual

MODEL:

Natural Gas Only

0743512

MODEL:

Propane Gas Only

0743511

Installation Instructions and Owner’s Manual

Direct-Vent Wall Furnace

WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer, service agency or the gas supplier.

WARNING: Installation and repair must be done by a qualified service person. The furnace should be inspected before use and at least annually by a professional service person.

WARNING: If not installed, operated and

maintained in accordance with the manufacturer’s instructions, this

product could expose you to substances in fuel or from fuel combustion which can cause death or serious illness and which are known to cause cancer, birth defects or other reproductive harm.

WARNING: If the information in this manual is not followed exactly; a fire or explosion may result, causing property damage, personal injury or loss of life.

-Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

-WHAT TO DO IF YOU SMELL GAS

• Open all windows.

• Do not try to light any appliance.

• Do not touch any electrical switch.

• Do not use any phone in your building.

• Extinguish any open flame.

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire department.

-Installation and service must be performed by a qualified installer, service agency or the gas supplier.

Williams Furnace Co., 250 West Laurel Street, Colton, CA 92324 U.S.A.

Image 1
Contents Direct-VentWall Furnace General Information and Technical Data Table of ContentsInstallation Instructions to InstallerSafety Information for Users of LP Gas Safety Rules and General WarningsLP Gas Warning Odor That’s your signal to go into immediate actionSome Points to Remember Technical DataInstallation Wall InstallationThe furnace must be located on an outside wall Part Number WFL-STF088Outside Location for Vent Terminal 5.Place the insulating sheet on the support bracket and attach the bracket with insulation to the wall by tightening the five screws with washer. Figure 3 Be sure the bracket is horizontal Pressure Testing of the Gas Supply System Installing a New Main Gas CockGas Supply High Altitudes Canada Only High Altitudes US OnlyFirst Firing the Furnace Checking the Gas Inlet PressureOPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATINGTO TURN OFF GAS TO APPLIANCE Operating InstructionsLubrication of Moving Parts Checking and Adjusting the Gas Manifold PressureFlame Visual Check ServicingReplacement Parts