SCAN
STOP SYSTEM SCAN
Press the preprogrammed Scan button to stop System Scan.
– or –
1Jto enter menu mode.
2 | Lor Muntil | SYS | SCAN |
|
|
|
|
3 | Jto select | SYS | SCAN |
|
|
|
|
The display shows the current scan status.
4 Lor Muntil SCAN OFF
5Jto select the current setting.
•The Gsymbol disappears from the display.
Note: Your dealer/programmer can preprogram your radio when exiting System Scan to automatically revert to the last scan channel that had activity on it or to automatically revert to the channel where scan was initiated.
START AUTO SCAN
Auto Scan automatically starts scanning once a channel with Auto Scan enabled is selected. Select a channel that has been preprogrammed for Auto Scan by your dealer/programmer.
STOP AUTO SCAN
Select a channel that has not been preprogrammed for Auto Scan by your dealer/programmer.
•The Gsymbol disappears from the display.
TALKBACK
The Talkback feature allows you to respond to a transmission while scanning. If transmission is detected on a channel while scanning, the radio will stop on that channel for a default period of time after activity has ceased. This is referred to as “hangtime”. During this hangtime you may respond by pressing the PTT button.
Note: The LED scan indicator stops blinking while the radio is in hangtime. If the PTT button is not pressed after the preprogrammed hangtime, the radio returns to scanning channels.
English 28