Trane Model 012 GEH Microprocessor Design, Deluxe 24V features include Random Start, Diagnostics

Page 20

R

Features and Benefits

Deluxe Controls

Microprocessor Design

The 24 volt deluxe design is a micro- processor-based control board conve- niently located in the control box. The board is unique to Trane water-source products and is designed to control the unit as well as provide outputs for unit status and fault detection.

The Trane microprocessor board is fac- tory wired to a terminal strip to provide all necessary terminals for field connec- tions. See Figure 27 for the deluxe 24V control board.

Deluxe 24V features include: Random Start

The random start relay provides a time delay start-up of the compressor when cycling in the occupied mode. A new start delay time between 3 and 10 sec- onds is applied each time power is enabled to the unit.

Anti-short Cycle Timer

The anti-short cycle timer provides a three minute time delay between com- pressor stop and compressor restart.

Brown-out Protection

The brown-out protection function measures the input voltage to the con- troller and halts the compressor opera- tion. Once a brown-out situation has occurred, the anti-short cycle timer will become energized. The general fault contact will not be affected by this con- dition. The voltage will continue to be monitored until the voltage increases. The compressors will be enabled at this time if all start-up time delays have expired, and all safeties have been sat- isfied.

Compressor Disable

The compressor disable relay provides a temporary disable in compressor operation. The signal would be provid- ed from a water loop controller in the system. It would disable the compres-

sor because of low water flow, peak limiting or if the unit goes into an unoc- cupied state. Once the compressor has been disabled, the anti-short cycle time period will begin. Once the compressor disable signal is no longer present, and all safeties are satisfied, the control will allow the compressor to restart.

Generic Relay

The generic relay is provided for field use. Night setback or pump restart are two options that may be wired to the available relay. (Note: Night setback is available as factory wired). An external Class II 24VAC signal will energize the relay coil on terminals R1 and R2. Terminals C (common), NO (normally open), and NC (normally closed) will be provided for the relay contacts.

Safety Control

The deluxe microprocessor receives separate input signals from the refriger- ant high pressure switch, low suction pressure switch and condensate over- flow.

In a high pressure situation, the com- pressor contactor is de-energized, which suspends compressor operation. The control will go into soft lockout mode initializing a three minute time delay and a random start of 3 to 10 sec- ond time delays. Once these delays have expired, the unit

will be allowed to run. If a high pressure situa- tion occurs within one hour of the first situa- tion, the control will be placed into a manual lockout mode, halting compressor operation, and initiating the gener- al alarm.

In a low temperature situation, the low pres- sure switch will transi- tion open after the com- pressor starts. If the

switch is open for 45 seconds during compressor start, the unit will go into soft lockout mode initializing a three minute time delay and a random start of 3 to 10 second time delays. Once these delays have expired, the unit will be allowed to run. If the low pressure situation occurs again within 30 min- utes, and the device is open for more than 45 seconds, the control will be placed into a manual lockout mode, halting compressor operation, and initi- ating the general alarm.

In a condensate overflow situation, the control will go into manual lockout mode, halting compressor operation, and initiating the general alarm.

The general alarm is initiated when the control goes into a manual lockout mode for either high pressure, low pressure or condensate overflow condi- tions.

Diagnostics

Component device connections to the microprocessor board are referenced in Figure 25. Three LEDs (light emitting diodes) are provided for indicating the operating mode of the controller. See the unit IOM for diagnostics or trou- bleshooting through the use of the LEDs.

Figure 25: Deluxe 24V control board.

20

WSHP-PRC003-EN

Page 19 Page 21
Image 20
Page 19 Page 21
Contents WSHP-PRC003-EN Introduction Contents Digits 1-3 Unit Configuration Model NumberGeneral Data Table G1 General Data GEH 006 toTable G2 General Data GEH 024 to Table G3 General Data GEH 060 toTable G4 General Data GEV 006 to Table G5 General Data GEV 024 toTable G6 General Data GEV 048 to 024 030 036 040 042Table G7 General Data GEV 072 to Table G8 General Data GEH072 090 120 150 180 240Air-to-Refrigerant Coils Table G9 GEH/GEVTable G17 GEH/GEV 060 2-compr. circuit Features and Benefits Design AdvantagesGEH 1/2 to 5-Ton Cabinet GEV 1/2 to 5-Ton CabinetFeatures Benefits GEH/GEV 6 to 20-Ton CabinetAirflow Options 1/2 to 5 ton Airflow Options 6 to 20-tonAccess Panels 12-1/2 to 20-ton Hanging Device 1/2 to 5-tonHanging Device 6 to 12-1/2-ton Drain PanSchrader Connections 1/2 to 5-ton Co-axial Water-to-Refrigerant CoilCompressor and Co-axial Coil Isolation 1/2 to 5 ton Water Connections 1/2 to 5-tonBlower Housing Blower Motor 1/2 to 5 tonBlower Motor 6 to 20 ton Air-Side FilterBoilerless Control/Electric Heat option Waterside Economizer optionProper Hot Gas Design Hot Gas Reheat optionCommon Reheat Applications Controls Controls by TraneSafety Devices Basic ControlsBasic 24 Volt Controls Stand-alone SystemSmall Building Control Deluxe ControlsDeluxe 24V Electronic Controls Deluxe 24V features include Random Start Anti-short Cycle TimerCompressor Disable Safety ControlZN510 & ZN524 Controls Tracer ZN510 & ZN524 ControlsDirect Digital Controls Water Isolation Valves Entering Water Temperature SamplingWaterside Economizer Tracer ZN controller system installation Building Control AdvantagesHanging Devices and Duct Attachments Application ConsiderationsHanging the Horizontal Condensate trap installation Condensate TrapsDistributed Pumping System 40 F/ 4 C may require antifreeze in the water loopInstallation Made Easy Service Access

Model 180 GEV, 120 GEH, Model 012 GEH specifications

Trane, a leading name in HVAC (heating, ventilation, and air conditioning) systems, offers a diverse range of models designed to cater to different cooling needs. Among its notable products are the Trane Model 180 GEV, Model 120 GEH, and Model 012 GEH. Each of these units incorporates advanced technologies and features aimed at enhancing efficiency, durability, and overall performance.

The Trane Model 180 GEV is engineered for high-performance cooling and heating applications. One of its standout features is the variable-speed compressor, which allows for precise temperature control and significant energy savings. This model also integrates advanced inverter technology that optimizes energy consumption based on the load. The robust design of the unit ensures reliability even under extreme weather conditions, making it a favored choice for commercial and industrial sectors.

In contrast, the Trane Model 120 GEH is a versatile solution that focuses on efficiency and adaptability. This model is equipped with Trane’s exclusive Climatuff compressor technology, which enhances the reliability and longevity of the system. The Model 120 GEH also includes a user-friendly touchscreen interface, allowing for convenient adjustments and monitoring of the system's performance. Enhanced filtration systems contribute to improved indoor air quality, which is a critical factor for many users.

The Trane Model 012 GEH is designed for smaller spaces but does not compromise on performance. This compact unit boasts energy-efficient operation and is equipped with Trane’s proprietary Air-Cooled Scroll Compressors that enhance its cooling capacity while maintaining low operational noise levels. Its sleek design allows for easy installation in various settings, including residential areas. The Model 012 GEH also features enhanced reliability through its robust materials, ensuring that it can withstand varying environmental conditions.

All three models emphasize Trane’s commitment to sustainability and energy efficiency. With the incorporation of eco-friendly refrigerants and advanced heat exchange technologies, users can enjoy superior cooling performance while minimizing their environmental impact. Moreover, these models are backed by Trane’s comprehensive support, providing customers with peace of mind through warranties and service options.

In summary, Trane's Model 180 GEV, Model 120 GEH, and Model 012 GEH are exemplars of modern HVAC technology, offering various features tailored to meet specific cooling and heating requirements. Each model stands out for its unique capabilities, efficient operation, and robust design, reaffirming Trane's position as a trusted leader in the HVAC industry.
Top Page Image Contents