Tweeter Mounting
Your tweeter can be flush mounted into your panel with or without the 15° angle
WITH ANGLE RINGS
rings.
Back
Tweeter Angle
Mounting Ring
Nut
Place the
Tweeter tweeter through the
Cut a
15/16" (4.9 cm) Hole
Wire
Front Angle Ring and then into the panel.
the panel for the tweeter and wiring.
1-
Panel
| Front |
| |
Panel | Angle | Next place the | |
Ring | |||
| |||
|
|
Back Angle Ring over the Tweeter and line
Installation
WITHOUT ANGLE RINGS
Mounting | Place the tweeter into |
Tweeter |
|
|
|
| Tweeter |
| Nut |
| the panel and secure |
|
|
| by tightening (clock- |
Wire |
|
| wise) the Tweeter |
| Panel |
| Mounting Nut. |
|
| ||
|
|
|
up the narrow part of the Back Angle Ring with the wide part of the Front Angle Ring for proper operation.
|
| Back |
Attach the Tweeter |
| Angle |
| Ring | |
Tweeter |
| |
Mounting Nut (clockwise) | Mounting | Tweeter |
Nut |
| |
|
| |
but do not tighten |
|
|
completely. | Wire |
|
|
| |
|
| Front |
This is what you should end up with after securing the Tweeter to the panel using the Mounting Nut.
Tweeter
Mounting
Nut Tweeter
Wire
Panel | Angle | |
Ring | ||
|
Rotate all the parts in
unison until the tweeter is angled in the desired direction.
Panel
If necessary, the legs of the Tweeter Mounting Nut can be cut to fit
Secure the assembly by tightening (clockwise) the Tweeter Mounting Nut.
thicker panels. Trim each leg at the score line. Remove only 1 section from each leg at a time until desired length is achieved.
This is what you should end up with after securing the Tweeter to the panel using the Mounting Nut.
Back
Angle
Ring
Tweeter
MountingTweeter
Nut
Wire
Front
Angle
Panel Ring
12 | SS Component Systems |