State Industries Commercial Gas Water Heater instruction manual For Your Information cont’d

Page 26

For Your Information (cont’d)

Operational Conditions (cont’d)

“AIR” IN HOT WATER FAUCETS

WARNING

HYDROGEN GAS: Hydrogen gas can be produced in a hot water system that has not been used for a long period of time (generally two weeks or more). Hydrogen gas is extremely flammable and explosive. To prevent the pos- sibility of injury under these conditions, we recommend the hot water faucet be opened for several minutes at the kitchen sink before any electrical appliances which are connected to the hot water system are used (such as a dishwasher or washing machine). If hydrogen gas is pre- sent, there will probably be an unusual sound similar to air escaping through the pipe as the hot water faucet is opened. There must be no smoking or open flame near the faucet at the time it is open.

HIGH TEMPERATURE SHUT OFF SYSTEM

This water heater is equipped with an automatic gas shut off system. The high temperature shut off is built into the gas control valve. This system shuts off the gas supply to the water heater burner when high water temperatures are present. It is non-resettable. If the high temperature shut off activates, the diagnostic indicator light on the front of the thermostat will be “ON” (not blinking) and the gas control valve must be replaced. If this were to occur, turn “OFF” the entire gas supply to the water heater. Contact the local gas utility.

WARNING

Should overheating occur or the gas supply fail to shut off, turn “OFF” the manual gas control valve to the appliance.

VENTING MANUAL RESET SWITCH

There is a venting manual reset switch located on the vent- ing hood. If the switch is activated, it will not reset itself. Before resetting this reset switch, check for flue blockage and propriety of the venting system. To reset, press the red button.

BLOWER MOTOR

VENTING MANUAL

 

RESET SWITCH

VENTING HOOD

NOT ENOUGH OR NO HOT WATER

1.Check the manual gas shut off valve to be sure it is open.

2.If the diagnostic indicator on the front of the thermostat is blinking, the control must be manually reset by cycling the control system. To do this, turn the electrical power supply off and then on.

3.The gas control knob must be turned to the “ON” position.

4.The ON/OFF switch on the control box must be “ON”.

5.The temperature adjustment dial may be set too low. See the “Temperature Regulation” section.

6.The gas company can check the gas input to see if it is correct. An underfired water heater will not heat water as quickly.

7.Look for leaking or open hot water faucets. Make sure all are closed.

8.The cold water inlet temperature may be colder during the winter months. It will take longer to heat the water and seem like less hot water.

9.If you cannot find what is wrong, call the local gas util- ity and/or plumbing contractor.

WATER IS TOO HOT

1.The temperature adjustment dial may be set too high. See the “Temperature Regulation” section.

NOTE: A period of time is necessary after an adjust- ment has been made for the water temperature to reach the new temperature setting.

2.If lower temperature settings will not lower the water temperature shut off the water heater and call the local gas utility.

26

Image 26
Contents What to do if YOU Smell GAS For Your Safety AN Odorant is Added to the GASUsed by this Water Heater Save this Manual for Future ReferenceMust not be plugged or blocked General SafetyDischarge Pipe General Safety cont’d DEATH, Serious Bodily INJURY, or Property DamageTable of Contents Preparing for the New Installation IntroductionTypical Installation ILY INJURY, or Property Damage Locating the New Water HeaterFacts to Consider About the Location Combustion Air and Exhaust Locating the New Water Heater cont’dFacts to Consider About the Location cont’d Venting Through an Outside Wall ClearancesVenting Through Roof Clearances Wire FenceAir for Ventilation for Appliances Located Confined Spaces 18″Installing the New Water Heater Water PipingInstalling the New Water Heater cont’d Temperature-Pressure Relief ValveFilling the Water Heater WiringOptional Field Installed Wiring Wiring Diagram VentingVenting cont’d Venting Through AN Outside WallVent piping can be installed as follows Installing the New Water Heater contdVenting System Example Installations for ALL Models Minimum vent length for all models is 18 inchesVent Pipe Separation PrecautionsCementing PVC, ABS or Cpvc Pipe and Fittings Venting contd Connecting Vent to BlowerTypical installation Venting Through a RoofGas Piping Venting Through a Roof CONT’DSediment Trap GAS Piping with Flexible ConnectorGAS Piping with ALL Black Iron Pipe to GAS Control Its hookup? Installation ChecklistBefore Operating the Water Heater Model Rating PlateOperation OperatingBefore the Water Heater will Operate Operating cont’d Check for LeaksFor Your Safety Read Before Operating Temperature Regulation Operational Conditions For Your InformationStart Up Conditions For Your Information cont’d Operational Conditions cont’dVenting System Inspection Periodic MaintenanceBurner Cleaning Burner InspectionPeriodic Maintenance cont’d Leakage Checkpoints Troubleshooting Thermostat and GAS Supply CheckTroubleshooting cont’d Diagram for Electrical System Check on pages 32Use diagram on Electrical System CheckFrom facing Circulating Tank System GAS/WITH Single Storage System Installation DiagramsTWO Temp Water Heater Installation GAS/INSTANTANEOUS or StoragePrimary Plus Booster Water Heater Installation Installation Diagrams contdWater Heater Installation GAS/INSTANTANEOUS Or StorageRepair Parts ModelPart Description Part Number Repair Parts cont’dThis is a Repair Parts LIST, not a Packing List Page

Commercial Gas Water Heater specifications

State Industries has carved a niche for itself as a leader in the water heating industry, providing reliable solutions for various commercial applications. One of the standout products in their lineup is the State Industries Commercial Gas Water Heater. This powerhouse is designed to meet the demanding hot water needs of businesses, from restaurants and hotels to schools and hospitals.

One of the primary features of the State Commercial Gas Water Heater is its high efficiency. These units are engineered to deliver optimal performance while reducing energy costs. With innovative technologies such as a power vent system and advanced burner design, they maximize heat transfer and minimize heat loss. This efficiency not only translates to lower operating costs but also a reduced environmental impact, making it a smart choice for businesses looking to operate sustainably.

Durability is another hallmark of State Industries' gas water heaters. Constructed from robust materials, these units are designed to withstand the rigors of daily use in a commercial environment. The tanks are often lined with glass and reinforced to prevent corrosion, enhancing the longevity of the unit. Additionally, the use of high-quality components ensures minimal maintenance and reliable operation over time, allowing businesses to focus on their core activities rather than downtime due to equipment failure.

State's Commercial Gas Water Heaters also come equipped with advanced safety features. This includes built-in temperature controls, pressure relief valves, and flame failure protection, which work together to ensure safe operation even in high-demand situations. These features provide peace of mind to operators and help meet stringent safety standards, making them suitable for any commercial setting.

Furthermore, the versatility of these water heaters is remarkable. They are available in various sizes and configurations, allowing businesses to choose a model that perfectly fits their water heating requirements. Whether for high-volume hot water needs or continuous flow applications, State's Commercial Gas Water Heaters are designed to adapt.

In conclusion, the State Industries Commercial Gas Water Heater stands out as a top choice for businesses needing reliable and efficient hot water solutions. With its focus on efficiency, durability, safety, and versatility, this water heater is built to meet the rigorous demands of the commercial market while providing value and peace of mind to operators.