Honeywell NetAXS, 800-04410 manual 2Configuration System General Tab Fields

Configuring via the Web Server

Configuring the System

Table 2-2:Configuration > System > General Tab Fields

Parameter

Description

Boot Time

Displays the time that power was applied to the NetAXS™ panel.

Reset

Reboots the panel. A reset does not change the current configuration

in the database.

Anti-Passback

Enabled – Enables anti-passback, which prevents an entrant to an

area from passing his card back to another potential entrant.

Local – Enforces anti-passback only at doors configured locally to

the panel controlling the original card read.

Global – Enforces anti-passback at panels throughout the NetAXS™

system after a successful card read at any one of the system’s readers.

Forgiveness – Causes all system codes to be reset at midnight every

day. This enables a cardholder who exited the building in the evening

without using his card to use his card for entry the following

morning.

Gateway Panel Addr

Sets the panel address of the Gateway panel, or the panel directly

connected to the host system.

Web Session Timeout

Activates a web session timeout after the specified time period has

elapsed. Define the time period either in minutes or in hours. Enter

the number in the box, then select either minutes or hours.

Hybrid Mode

Enabled – Implements a superior method of communication that

provides dynamic database synchronization between the NetAXS™

database and WIN-PAK SE Release 2 or WIN-PAK PE Release 2. It

allows full web functionality while using a WIN-PAK SE Release 2

or WIN-PAK PE Release 2 as the host. When connected to

WIN-PAK SE Release 2 or WIN-PAK PE Release 2 or later,

WIN-PAK enables you to:

• approve changes made via the web interface.

• import those changes into the WIN-PAK database.

• disapprove those changes and revert the panel's

configuration to the configuration stored in the WIN-PAK

database.

Note: Consult your Honeywell Access Control representative for the

latest list of Host software packages that support this feature.

Free Egress

Enabled – Configures the panel for free egress. Reader 1 activates

output 1, reader 2 activates output 2, reader 3 activates output 3, and

reader 4 activates output 4. Inputs 1, 3, 5, and 7 are egress defaults

that activate outputs 1, 2, 3, and 4, respectively. Inputs 2, 4, 6, and 8

are status defaults for outputs 1, 2, 3, and 4, respectively.

NetAXS™ Access Control Unit User’s Guide, Document 800-04410, Revision A

15