![](/images/new-backgrounds/1053120/53120153x1.webp)
Configuring via
Adding a New NetAXS™ Panel
3.2.2 Configuring the Panel Manually
Use the
Note: You cannot initialize the NetAXS™ panel from the
If you are using the Device Map to add the NetAXS™ panel manually, add it as you would an
1.Display the Basic tab of the
Figure 3-2: WIN-PAK Panel Configuration Screen - Basic Tab
2.Enter the following selections for the remaining fields:
–Firmware version – 8.07 or later.
–Status – Active.
–Address – Select the appropriate panel number.
NetAXS™ Access Control Unit User’s Guide, Document | 67 |