Honeywell 800-04410, NetAXS manual Configuration System General screen see General Tab

Setting

Description

Anti-Passback

Configures the anti-passback feature, which prevents an entrant

to an area from passing his card back to another potential

entrant. Note that anti-passback must first be enabled at the

Configuration > System > General screen (see General Tab,

page 14).

Enabled – Enables the anti-passback feature.

Hard – Does not allow a second entry on the same card without

an exit; validates in/out status before allowing entry.

Soft – Allows entry on the same card without an exit; however,

an event is generated that indicates violation.

Out – Applies to readers located inside the area. Cardholders use

these readers when attempting to exit the area.

In – Applies to readers located outside the area. These are

readers that cardholders use when attempting to enter the area.

Duress Output

Configures the output that will trip when a cardholder enters a

“duress PIN” at a keypad/card reader. A duress PIN is the PIN a

user enters at a keypad when being forced (perhaps in a robbery)

to open a door. The user enters his normal PIN, except one of the

digits is one number higher or lower than the normal digit. This

PIN opens the door, but it also triggers the designated duress

output and produces an alarm.