System Operation (cont’d)
When the System is Not Ready
If the system is not ready to be armed, the READY LED is off and the display indicates which zone or zones are not ready.
Determine which zone or zones are not ready, resolve the problem, and arm the system normally. If the problem cannot be resolved, you may bypass the zone that is not ready. Bypassing should only be done if the problem on the zone cannot be resolved, OR if you intentionally wish to leave the zone disarmed. For example, you would leave the zone disarmed if you plan to keep the window open for ventilation. Zones that are bypassed are not protected when the system is armed. Refer to the paragraph entitled, “To Bypass a Zone” for a description of the procedure.
To Arm the System and Stay Inside
To arm the perimeter portion of your burglar alarm and move around freely inside the premises, use the STAY mode.
Check to make sure the system is ready. When it is ready, press:
STAY
followed by your user code.
When the system has been armed successfully, the ARMED LED is on, and the following is displayed:
LCD Keypad:
ON: STAY
STAY
REMEMBER: You must disarm the system if you want to open the door or leave the premises after the exit time has passed.
– 11 –