Whirlpool WHES30, WHES20 manual Inspect Shipment, Do not return the water softener to store

Page 4

The water softener requires a minimum water flow of 3 gallons per minute at the inlet. Maximum allowable inlet water pressure is 125 psi. If daytime pressure is over 80 psi, nighttime pressure may exceed the maximum. Use a pressure reducing valve if necessary. (Adding a pressure reducing valve may reduce the flow.) If your home is equipped with a back flow preventer, an expansion tank must be installed in accordance with local codes and laws.

The water softener works on 24 volt-60 hz electrical power only, supplied by a direct plug-in transformer (included). Be sure to use the included transformer and plug it into a nominal 120V, 60 cycle household outlet that is properly protected by an overcurrent device such as a circuit breaker or fuse. If transformer is replaced, use only the authorized service, Class II, 24V 10VA transformer.

This system is not intended to be used for treating water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

European Directive 2002/96/EC requires all electrical and electronic equipment to be disposed of according to Waste Electrical and Electronic Equipment (WEEE) requirements. This directive or similar laws are in place nationally and can vary from region to region. Please refer to your state and local laws for proper disposal of this equipment.

Inspect Shipment

The parts required to assemble and install the water softener are included with the water softener.

Ground clamp

Single valve bypass

20 ft. drain hose

Hose adaptor

Hose clamps

Installation adaptors

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Clips

O-rings

Grommet

Water hardness test strip

Thoroughly check the water softener for possible shipping damage and parts loss. Also inspect and note any damage to the shipping carton.

Remove and discard (or recycle) all packing materials. To avoid loss of small parts, we suggest you keep the small parts in the parts bag until you are ready to use them.

Do not return the water softener to store.

If you have any questions, or there are missing parts or damage, please call 1---866---986---3223, Monday --- Friday, 8 am --- 9 pm EST.

Before you call please have your model number, date of purchase, water conditions and number of people living in your home.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Model WHES20 Model WHES30 Table of Contents Water Softener Safety Before You StartInspect Shipment Do not return the water softener to storeWater Softener Dimensions How a Water Softener Works Water Conditioning InformationSoftening Cycle Regeneration Cycle150 Installation Requirements Tools and Parts NeededLocation Requirements Air Gap RequirementsValve Drain Requirements Plan the Installation Inlet --- Outlet Plumbing OptionsInstall the Brine Tank Overflow Elbow InstallationTurn Off Water Supply Move the Water Softener into Place Assemble Inlet and Outlet Plumbing Connect Inlet and Outlet PlumbingInstall Salt Storage Tank Overflow Hose Install Valve Drain HoseTest for Leaks Add Water and Salt to the Salt Storage Tank Sanitize the Softener/Sanitize After ServicePlug in Water Softener Program the Water Softener -- Model WHES20 Set Time of DaySet Recharge Regeneration Time Set Water Hardness NumberStart a Recharge Program the Water Softener -- Model WHES30 SET Salt Level button DisplayHardness Number Customizing Features/Options -- Model WHES20 ‘‘Power---Outage Memory’’Recharge Recharge TonightSalt Efficiency Recharge Scheduled Customizing Features/Options-- Model WHES30Set Salt Level Water Flow Indicator Clean / Clear Water Iron Removal Clean Feature MinutesMaximum Days Between Regenerations 12 or 24 Hour ClockRefilling With Salt Routine MaintenanceBreaking a Salt Bridge Cleaning the Nozzle and Venturi Troubleshooting Guide Problem Cause SolutionAutomatic Electronic Diagnostics Manual Advance Diagnostics --- Model WHES20Manual Advance Regeneration Check --- Model WHES20 Manual Advance Diagnostics --- Model WHES30 Manual Advance Regeneration Check --- Model WHES30 Performance Claims Product SpecificationsVariable Salt Dose Wiring Schematic WarrantySoftener Components Key Description Wear-strip Seal Cross-section View 12 11 Key Part Description

WHES30, WHES20 specifications

The Whirlpool WHES30 and WHES20 are innovative water softeners designed to enhance the quality of your home’s water supply. These models are engineered to effectively reduce hard water minerals such as calcium and magnesium, providing soft water that helps protect your plumbing and appliances from scale buildup while improving the efficiency of soap and detergent.

One of the standout features of the WHES30 and WHES20 is their capacity. The WHES30 has a higher capacity, making it suitable for larger households requiring consistent soft water for daily use. It can handle water hardness levels of up to 120 grains per gallon and is designed to accommodate up to 30,000 grains of hardness removal, ensuring that even in high-demand scenarios, families can rely on a consistent supply of softened water. In contrast, the WHES20 is ideal for smaller households or those with milder water hardness issues, capable of managing up to 20,000 grains.

Both models utilize a demand-initiated regeneration process, which is an energy-efficient technology that allows the systems to regenerate only when necessary. This not only saves water and salt but also extends the lifespan of the system. The softeners use a high-efficiency brining cycle, which reduces waste and enhances performance, ensuring that you have soft water available at all times.

The Whirlpool WHES series also features easy-to-use digital controls. This user-friendly interface enables homeowners to easily monitor and program the system settings according to their specific needs. Detailed diagnostic information is displayed, allowing users to track water usage and maintenance schedules efficiently.

Additionally, both water softeners come equipped with a two-in-one system design that incorporates a built-in brine tank, simplifying installation and saving valuable space in your home. The compact nature of these models ensures they can fit into various locations without taking up excessive room.

In terms of construction, the WHES30 and WHES20 are durable and designed for longevity. They are built with sturdy materials that resist corrosion and ensure reliable performance over the years. This commitment to quality makes these water softeners a valuable investment for any household.

Overall, the Whirlpool WHES30 and WHES20 models deliver user-friendly operation, efficient performance, and high-quality components, making them excellent choices for anyone looking to improve their water quality through effective softening technology.
Top Page Image Contents