Operating Your Air Conditioner

To obtain the best oossible results from vour air conditioner. it is imoortant that vou ooerate it properly. This section tells you how to set the controls and how to direct the cooled air.

Starting your air conditioner

1.Set Exhaust Control to CLOSED for maximum cooling performance.

(See “Using the exhaust vent control” on page 6.)

2.Set the Selector Control to the desired setting.

COOL-for cooling the room air HEAT-for heating the room air FAN ONLY-for circulating rmrn air without cooling or heating it

3.Set the Fan Control to the desired setting. You can use either the ENERGY SAVER or NORMAL FAN settings. (See “Using the energy saver settings” below.) LOW - for sleeping comfort

MED - for normal cooling

QUICK COMFORT - for fastest cooling NOTE: This product is not designed to be used as a primary heat source. It is intended for supplemental heating only. HEAT mode operation is not recom- mended when the outdoor temperature is below 45°F.

4.Turn the Thermostat Control to a mid-setting. You can adjust the air conditioner’s cooling performance by turning the Thermostat Control toward COOLER for more cooling or toward WARMER for less cooling. You will need to experiment to find the setting which suits you best.

Electrical Shock Hazard

l Plug unit only into grounded electrical outlet.

l Do not use an extension cord.

l Do not operate unit with the front panel removed.

Failure to follow the above precautions could result in electrical shock or personal injury.

IMPORTANT: If you turn the air conditioner off, or if the compressor turns off when you lower the Thermostat Control, wait at least 3 minutes before turning the air conditioner back on. If you don’t wait, you may blow a fuse or trip a circuit breaker.

Using the energy saver settings

Use the ENERGY SAVER settings when you do not want the fan to run continuously. Using these settings causes the fan to stop when the compressor stops and saves energy.

Set the Fan Control to the desired setting.

LOW - for sleeping comfort

MED - for normal cooling

QUICK COMFORT - for fastest cooling