Meridian Audio 501V manual NCon, To connect to other Meridian 500 Series equipment, Auto

To connect to other Meridian 500 Series equipment

●Connect one of the COMMS sockets on the rear panel of the control unit to one of the COMMS socket on another 500 Series unit (excluding the 563), using the 500 comms lead provided with the other unit.

The sequence in which you connect the units is not important.

COMMS COMMS

Then configure the units with the following automatic setup procedure:

●Switch all the units to standby.

●Press Clear on the handset.

Each unit will display:	Auto
One unit will then be designated	Con
as the controller, and display:

This is the unit that will respond to the handset.

All the other units will be configured	NCon
as non-controllers, and display:

Your system is now set up and ready for use.

●If, for any reason, the automatic setup does not give the configuration you want, restore the default operation by selecting Type 1 as described in To connect to Meridian 600 or 200 Series equipment, page 38.

●If you want to change the automatic setup configuration refer to the Meridian 500 Series User Guide.

Note: Do not, under any circumstances, connect any equipment other than Meridian 500, 600, or 200 Series to the socket marked COMMS on the rear of the control unit.

Setting up the Control Unit

37