Meridian Audio 501V manual Choosing standard settings, Type, To select a standard setting, Unit

Choosing standard settings

The 501/501V Control Unit provides six alternative standard settings, called Types, which configure all aspects of the control unit into the six most commonly needed configurations.

Choosing one of the six standard settings overrides any other configuration you may have performed, and so can be used to reset the configuration of the control unit.

By default, the control unit is supplied set to Type 1.

To select a standard setting

●Switch off any power amplifiers that are connected to the control unit.

●Turn off the control unit, using the power switch on the back panel.

●Turn on the power again while holding down the Off key on the front panel.

Unit

If you have a system containing only Meridian 500 Series units then you should choose one of Types 5, 1, 4, or 3. These give progressively larger numbers of inputs, as shown in the tables

The display will show:

Type

on page 21 (501) or page 22 (501V).

It will then show:

Ty 1

Customising the Control

If your system includes any Meridian 600 or 200 Series units you should choose Type 2 or Type 6. For more information see To connect to Meridian 600 or 200 Series equipment, page 38.

●Press V or A to change the type number.

For example, to select Type 3	Ty 3
the display shows:

●Turn off the control unit using the power switch on the back panel.

●Turn on again to use the standard settings you have selected.

20