Meridian Audio 501V Selecting a source, CD65, To switch on from standby, To select a source

Selecting a source

During normal use the control unit should be left in the standby	For example, if you select the		CD65
state. This uses a negligible amount of electricity, but ensures	CD input the display will show:
that the components of the control unit operate at maximum
efficiency from the moment you start.	By default, the following six sources are available:
If you are not going to use the control unit for a period of several	Source	Label	Input
days you should switch the unit completely off, at the rear panel,
	CD	CD	A2
and disconnect it from the AC power supply.
	Radio	RD	A3

To switch on from standby

●Press Source (front panel), or select a source by pressing the appropriate source key on the remote control.

If the 501/501V Control Unit is part of a Meridian system, it will automatically switch on any other unit in the system, such as the CD player.

To select a source

LP	LP	A1
TV	TV	A5
Tape1	T1	A4
Tape2	T2	A6

To switch to standby

● Press Off (front panel) or Standby (remote control).

Using the

●Press Source (front panel) until the display shows the source you require, or press the appropriate source key on the remote control.

The display will show:

.

Control Unit

The display shows the source, and volume setting.

If you have other Meridian 500 Series equipment connected to the control unit, these units will also switch to standby.

11