Squeezebox™ Duet User Guide | 7 |
|
|
Set Up the Hardware
Charge the Battery
For this step you’ll need:
•Squeezebox Controller
•Charging cradle with AC adapter
•Plug adapter for your region
•Battery
You’ll start the installation process by charging the battery so it will be ready when you configure Squeezebox Controller and Receiver for your network.
1.Select the correct plug adapter and slide it onto the AC adapter of the charging cradle. Make sure it snaps firmly into place.
2.Plug the AC adapter into an electrical outlet.
3.Insert the battery into the Controller:
•Remove the battery cover on the back of the Controller. Use your thumbs to press down on the battery cover, and then slide it toward the bottom of the unit; it should move about 1/4 inch.
•Insert the battery, making sure the This Side Up label faces up and reads correctly.
•Place the battery
•Replace the battery door, fitting the tabs on the door into the slots on the Controller.
•Slide the battery door up toward the top of the Controller so it locks into place.
4.Place the Controller into the charging cradle. The Controller powers on and the battery pack begins charging. It may take up to four hours to charge the battery pack fully. However, you do not need a full charge to set up the Controller.