Whirlpool ACSIOZ ACS520 warranty Unplug the power cord

1.Unplug the power cord.

2.Remove the air intake panel. (See “Cleaning the air intake paner on page 20.)

3.Remove 2 Phillips-head screws holding front panel frame in place. Then remove front panel frame the same way you removed the air intake panel.

4.Remove the air conditioner from the window.

5.Remove the 6 slotted hex-head screws along the base of the cabinet (3 per side- as shown).

6.Remove the 1 slotted hex-head screw from the left side of the cabinet (as shown).

7.Holding the cabinet on both sides, carefully

lift cabinet off base. 6crm

6.Wrap the motor, electrical control box and compressor terminal box in plastic film to make sure no water or other liquids get inside. Water or other liquids could damage the insulation and cause serious mechanical problems.

9.Clean and hose out the base, coils and condensate pans. Clean air conditioner at least once a year or more often if the condenser coils and pans collect dirt, sand, leaves, insects or algae. Also, clean the air conditioner if you detect an odor coming from it.

10.Remove plastic film from the motor and electrical parts.

11.Replace cabinet over base and tighten all screws.

12.Reinstall air conditioner in the window.

13.Replace the air intake panel and front panel frame.

14.Plug in the power cord.

NOTE: It is a good idea to wait 24 hours before starting the air conditioner again. Doing so allows time for all areas to dry thoroughly.

The water from rainfall or from normal operation does not harm the motor or electrical parts.

22