Whirlpool ACSIOZ ACS520 warranty Feeten eiding

5.Adjust the piatforrn ueembfy so that the rear of the air conditioner will be %-inch lower than the front. This ensures proper water drainage from the air conditioner.

NOTE: A projection below the base of the air conditioner will require the rear of the platform to be %a-inch lower than the front to create the 3/ibinch slat from front to rear.

6.Securely ettach a ridingprotection board to the side of the house where the platform assembly hits the house. The siding-protection board should be long enough to span 2 wall studs.

7.Meaeure the height of the window opening from the top of the platform assembly. Subtract 20% inches (the height of the air conditioner cabinet). Mark this measurement on the plastic window panel-along the longer side.

6.Clamp the pleetlc window penel between a board and a work table and cut along the cutting line with a fine tooth saw. Remove any burrs with a file.

9.Lii the panel frame from the side channels of the air conditioner cabinet. Slide the plastic window panel into the frame with the smooth side to the outside. Slide the panel frame assembly back into the side channels of the air conditioner cabinet. Make sure the plastic window panel is firmly enclosed on all sides by the retainer grooves.

Reu is et beet 7/t0-in& lower

Feeten eiding-

dprotmtion bored to the heuee eiding.

14