Allied International Home Security System manual Guppy changing filters safety instructions

Safety instructions

GUPPY: changing filters safety instructions

Old CS-/C-Mounting	New CS-/C-Mounting
	starting with serial no. 06/05-84312215
CS-Mount models have the filter or protection	All models have the filter or protection glass
glass mounted directly in front of the sensor. Tak-	mounted directly in the CS-Mount adapter. (Stan-
ing out the filter or protection glass is not possi-	dard delivery is a CS-Mount camera). Taking out
ble at customer site.	the filter or protection glass is not possible at cus-
Ask your dealer for a camera with the respective	tomer site.
filter already installed.	Ask your dealer for a camera with the respective
	filter already installed.
C-Mount models have the filter or protection glass	In order to get a C-Mount camera, screw the 5 mm
mounted in the CS- to C-Mount extension adapter.	C-Mount adapter onto the CS-Mount camera.
Ask your dealer for an extension adapter with the	Unscrew the 5 mm C-Mount adapter to get again a
intended filter already mounted.	CS-Mount camera.
Removing the C-Mount adapter opens the front	Removing the CS-Mount adapter opens the front
section of the camera. This greatly enhances the	section of the camera. This greatly enhances the
risk for dust or particles to migrate on the sensor's	risk for dust or particles to migrate on the sensor's
protection glass.	protection glass.
In order to remove the adapter:	In order to remove the adapter:
Hold the camera so that the adapter points down-	Hold the camera so that the adapter points down-
wards while changing the adapter. Use optical	wards while changing the adapter. Use optical
cleaning tissues for cleaning the sensor's protec-	cleaning tissues for cleaning the sensor's protec-
tion glass if needed. Never use compressed air	tion glass if needed. Never use compressed air
for cleaning purposes.	for cleaning purposes.
Ask your dealer if you are not familiar with these	Ask your dealer if you are not familiar with these
procedures.	procedures.

Table 3: Old and new CS-/C-Mounting of GUPPY cameras

PIKE/OSCAR: changing filters safety instructions

Note	• Pike/Oscar models only: Changing filters is achieved
	by changing back focus rings with the appropriate filter
	already mounted. Please be advised that back focus
	adjustment will be necessary in order to match C-Mount
	distance of 17.526 mm. Ask your dealer for further
	information or assistance.

Hardware Installation Guide V2.0.0

13