Speco Technologies SIPSD37X Preset, Deleting Swings To delete Swings, enter into OSD menu

			OPERATION 3
		Preset
z	Function		MAX. 127 positions are programmable. The Preset number can be
			assigned from 1 to 128 except 95. Preset 95 is reserved for entering
			into OSD menu. Camera parameters such as White Balance, Auto
			Exposure and others can be set up independently and each preset
			can have its own parameter values independently from the other
			persets. When setting up presets with a controller, Label should be
			blank and "Camera Adjust" should be set to "GLOBAL" as the
			default. To change the parameters, enter into OSD menu.
z	Setting Presets		Set Preset [1~128]
z	Running Presets		Go Preset [1~128]
z	Deleting Presets		To delete Presets, enter into OSD menu.
		Swing
z Function			This function is that the camera moves repetitively between two
			preset positions at programmed speeds. When a swing function
			runs, the camera moves from the preset assigned as the 1st point to

the preset assigned as the 2nd point in CW(Clockwise) direction. Then the camera moves from the preset assigned as the 2nd point to the preset assigned as the 1st point in CCW(Counterclockwise) direction.

1st Preset

		n
	io
	t		2nd Preset
	ir
	c
	e
	D
1	CW		n
			io
			t
			c
			e
			r
			i
			D
	2	CCW

In case that the preset assigned as the 1st point and the preset assigned as the 2nd point are same, the camera turns on its axis by 360° in CW(Clockwise) direction and then it turns back on its axis by 360° in CCW(Counterclockwise) direction. The Swing speed is defined from 1°/sec to 180°/sec.

z	Setting Swings	To set Swing, enter into OSD menu.
z	Running Swings	Method1)	<Run Pattern>[SwingNO. +10]	ex)RunSwing3	: <RunPattern>[13]
		Method2)	<Go Preset>[SwingNO. +140]	ex) RunSwing3	: <Go Preset>[143]
z	Deleting Swings	To delete Swings, enter into OSD menu.

37X Speed Dome Camera 20/50