Speco Technologies SIPSD37X, HTSD37X specifications Check Points before Operation

OPERATION 3

Check Points before Operation

zBefore turning on the system, check if the wire(s) and cable(s) are connected properly.

zCheck if the camera ID on the controller is properly selected. The camera ID must be identical to that of the target camera. The camera ID can be checked by reading the DIP switch of the camera or on OSD.

zIf your controller supports multi-protocols, the protocol must be changed to match to that of the camera.

zAdjust the DIP switch after turning off the camera. If you changed the camera protocol by changing the DIP S/W, the change will be effective after you reboot the camera.

zSince the operation method can be different by controllers, refer to your controller manual if the camera can not be controlled properly. The operation of this manual is based on the standard Pelco® Controller.

Check Points for Preset and Pattern Function before Operation

zCheck fully how to operate preset function and pattern function with your controller or DVR in advance to operate the camera functions when using a controller or a DVR.

zRefer to the following table when using standard Pelco® protocol controllers.

<Go Preset > Input[PresetNumber]andpress[Preset]button shortly.

<Set Preset > Input [Preset Number]andkeeppressing [Preset]button for more than2 seconds.

<Run Pattern > Input [Pattern Number] and press [Pattern] buttonshortly.

<Set Pattern > Input [Pattern Number]and keeppressing[Pattern] buttonformore than 2seconds.

zIf your controller or DVR has no pattern button or function, use the Hot Keys with preset numbers. For more information, refer to “Reserved Presets(Hot Keys)” in this manual.

37X Speed Dome Camera 18/50