HP xw6000 manual Post Error Messages, Screen Message Beeps Probable Cause Recommended Action

C

POST Error Messages

An error message results if the Power-On Self-Test (POST) encounters a problem. This test runs when the system is turned on, checking assemblies within the computer and reporting any errors found.

POST Error Messages

Screen Message	Beeps*	Probable Cause	Recommended Action
101-Option ROM Error	1L, 1S	System ROM checksum.	Verify the correct ROM.
			Flash the ROM if needed.
			If an expansion card was recently
			added, remove it and see if the
			problem remains.
			Clear CMOS.
			If the message disappears, there
			may be a problem with the
			expansion card.
			Replace the system board.
102-System Board	None	DMA, timers, etc.	Clear CMOS.
Failure			Remove expansion boards.
			Replace the system board.
103-System Board	None	DMA, timers, etc.	Clear CMOS.
Failure			Remove expansion boards.
			Replace the system board.
150-SafePost Active	None	A PCI expansion card is	Restart the computer.
		not responding.	Disable SafePost.
			If the expansion card does not
			respond, replace the card.
162-System Options	2S	Configuration incorrect.	Run Computer Setup (F10 Setup).
Not Set		RTC (real-time clock)	Set the date and time under Control
		battery may need to be	Panel or in F10 Setup depending on
		replaced. Battery life is	the operating system.
		approximately 3 years.	If the problem persists, replace the
			RTC battery.
* L = Long, S = Short

Service Reference Guide C–1