HP xw6000 manual Test Error Codes, XXXX-21

				Diagnostic Error Codes
Test Error Codes
	Error Code	Description		Recommended Action
	XXXX-02	Drive not installed.	Check cable connections.
	XXXX-03	Media not in drive.	Check for and install data CD or write-enabled
			tape in drive.
	XXXX-05	Seek failure.	Replace the indicated device.
	XXXX-06	Drive timed out.	Replace the indicated device.
	XXXX-07	Drive busy.	Replace the indicated device.
	XXXX-08	Drive already reserved.	Replace the indicated device.
	XXXX-09	Unknown.
	XXXX-10	Unknown.
	XXXX-11	Media soft error.	Replace the indicated device.
	XXXX-12	Drive not ready.	Replace the indicated device.
	XXXX-13	Media error.	Replace the indicated device.
	XXXX-14	Drive hardware error.	Replace the indicated device.
	XXXX-15	Illegal drive command.	Replace the indicated device.
	XXXX-16	Media was changed.	Replace the indicated device.
	XXXX-17	Tape write-protected.	1.	Disable write-protect on tape cartridge.
			2.	Replace tape drive.
	XXXX-18	No data detected.	Replace the indicated device.
	XXXX-21	Drive command aborted.	Replace the indicated device.
	65XX-24	Media hard error.	1.	Back up data and perform Surface Analysis
				to reallocate defect.
			2.	Replace drive.
	66XX-24	Media hard error.	1.	Replace current data CD with different data
				CD.
			2.	Replace drive.
	67XX-24	Media hard error.	1.	Ensure correct media type for this tape
				drive.
			2.	Replace current tape with new tape.
			3.	Replace tape drive.
	XXXX-25	Unknown.
	XXXX-30	Controller timed out.	Replace the indicated device.
	XXXX-31	Unrecoverable error.	Replace the indicated device.
	XXXX-32	Controller/drive disconnected.	Replace the indicated device.
	XXXX-33	Illegal controller command.	Replace the indicated device.
	XXXX-34	Invalid SCSI bus phase.	Replace the indicated device.

Service Reference Guide E–11