HP xw6000 manual Not working

POST Error Messages

POST Error Messages

Screen Message	Beeps*	Probable Cause	Recommended Action
402-Monochrome	1L, 2S	Monochrome display	Replace monochrome display
Adapter Failure		controller.	controller.
403-Parallel Port 3	2S	IRQ address conflicts	Reset the IRQ.
Address Assignment		with another device.
Conflict
404-Parallel Port	2S	Both external and	Remove any parallel expansion
Address Conflict		internal ports are	cards.
Detected		assigned to parallel port	Clear CMOS.
		X.	Reconfigure card resources and/or
			run Computer Setup (F10 Setup).
410-Audio Interrupt	2S	IRQ address conflicts	Reset the IRQ.
Conflict		with another device.
411-Network Interface	2S	IRQ address conflicts	Reset the IRQ.
Card Interrupt Conflict		with another device.
501-Display Adapter	1L, 2S	Graphics display	Reseat the graphics card (if
Failure		controller.	applicable).
			Clear CMOS.
			Verify that the monitor is attached
			and turned on.
			Replace the graphics controller.
510-Splash Screen	None	Splash Screen image	Install latest version of ROMPaq to
image corrupted		has errors.	restore image.
511-CPU, Rear, or Front	None	Fan is not connected or	Reseat fan cable.
Fan not detected		may have	Replace the fan.
		malfunctioned.

512-Chassis fan not	None	Fan is not connected,
detected		may have
		malfunctioned, or fan
		driver on system board is
		not working.

Reseat fan cable. Replace the fan. Replace system board.

601-Diskette Controller	None	Diskette controller	Run Computer Setup (F10 Setup).
Error		circuitry or floppy drive	Check and/or replace cables.
		circuitry incorrect.	Clear CMOS.
			Replace diskette drive.
			Replace the system board.
602-Diskette Boot	None	Diskette in drive A not	Replace the diskette.
Record Error		bootable.
* L = Long, S = Short

C–4 Service Reference Guide