HP xw6000 manual Test Error Codes

Diagnostic Error Codes

Test Error Codes (Continued)

Error Code	Description		Recommended Action
XXXX-35	Invalid SCSI bus phase.	Replace the indicated device.
XXXX-36	Invalid SCSI bus phase.	Replace the indicated device.
XXXX-39	Error status from drive.	Replace the indicated device.
XXXX-40	Target timed out.	Replace the indicated device.
XXXX-41	SCSI bus stayed busy.	Replace the indicated device.
XXXX-42	ACK/REQ lines bad.	Replace the indicated device.
XXXX-43	ACK did not deassert.	Replace the indicated device.
XXXX-44	Parity error.	Replace the indicated device.
XXXX-50	Data pins bad.	Replace the indicated device.
XXXX-51	Data line 7 bad.	Replace the indicated device.
XXXX-52	MSG, C/D, and/or I/O lines	Replace the indicated device.
	bad.
XXXX-53	BSY never went busy.	Replace the indicated device.
XXXX-54	BSY stayed busy.	Replace the indicated device.
XXXX-60	Controller CONFIG-1 register	Replace the indicated device.
	bad
XXXX-61	Controller CONFIG-2 register	Replace the indicated device.
	bad
XXXX-65	Media not unloaded.	Replace the indicated device.
XXXX-90	Fain failure.	1.	Ensure fan(s) connected.
		2.	Replace nonfunctional fan(s).
XXXX-91	Over temperature.	1.	Ensure proper air flow.
		2.	Perform required maintenance and
			cleaning.
XXXX-99	Autoloader reported tapes not	1.	Install tape(s) in autoloader tape drive
	loaded properly.		according to test instructions.
		2.	Change autoloader magazine.

E–12 Service Reference Guide