HP xw6000 manual Board

POST Error Messages

POST Error Messages

Screen Message Beeps* Probable Cause Recommended Action

163-Time & Date Not	2S	Invalid time or date in
Set		configuration memory.

RTC (real-time clock) battery may need to be replaced. Battery life is approximately three years.

CMOS jumper may not be properly installed.

Set the date and time under Control Panel or in F10 Setup depending on the operating system.

If the problem persists, replace the RTC battery.

Check for proper placement of the CMOS jumper.

164-Memory Size Error	2S	Memory configuration is	Run Computer Setup (F10 Setup) or
		incorrect.	Windows utilities.
			Make sure memory module(s) (if
			any) are installed properly.
			If third party memory has been
			added, test using HP-only memory.
			Verify proper memory module type.
183-Invalid Processor	2S	System board jumper	Reset system board jumpers to match
Jumper Setting		improperly set.	processor and bus speeds.
201-Memory Error	None	RAM failure.	Run Computer Setup (F10 Setup) or
			Windows utilities.
			Ensure memory and continuity
			modules are installed correctly.
			Verify proper memory module type.
			Remove and replace memory
			module(s) one at a time to isolate
			faulty module.
			Replace the faulty memory
			module(s).
			If error persists after replacing
			memory modules, replace the system
			board.
202-Memory Type	None	Memory modules do not	Replace memory modules with
Mismatch		match each other.	matched sets.
* L = Long, S = Short

C–2 Service Reference Guide