5.4 Operating using the Default Master Source Signal Selection
The DEFAULT SELECT switch is factory preset to IN 1 and the WP-211DSwill detect the presence of the master source signal at the XGA INPUT 1 connector. If you connect active sources to both the XGA INPUT 1 and the XGA INPUT 2 connectors, the source at the XGA INPUT 1 connector takes priority over the source at the XGA INPUT 2 connector and it is routed to the XGA OUT and the AUDIO OUT connectors (audio follows the video).
You can change the default so that the WP-211DSautomatically detects an active source signal from XGA INPUT 2, by setting the DEFAULT SELECT switch to IN 2. When active, the source at the XGA IN 2 connector takes priority over the source at the XGA INPUT 1 connector and it is routed to the XGA OUT and the AUDIO OUT connectors (audio follows the video).
If the WP-211DSdetects:
No signal1 at the XGA INPUT 1 input (when INPUT 1 is selected as the default), the WP-211DSroutes the signal from the source at XGA INPUT 2 and AUDIO IN 2 to the XGA OUT and the AUDIO OUT connectors.
Similarly, if the WP-211DSdetects no signal at the XGA INPUT 2 input (when IN 2 is selected as the default), the WP-211DSroutes the signal from the source at XGA INPUT 1 and AUDIO IN 1 to the XGA OUT and the AUDIO OUT connectors
A signal from the XGA source at XGA INPUT 1 input (when IN 1 is
selected as the default), while routing the signal from the XGA source at XGA INPUT 2, the WP-211DSwill reroute the signal from the XGA source at XGA INPUT 1 and AUDIO IN 1 to the XGA OUT and the AUDIO OUT connectors. Similarly, if the WP-211DSdetects a signal from the XGA source at XGA INPUT 2 input (when IN 2 is selected as the default), while routing the signal from the XGA source at XGA INPUT 1, the WP-211DSwill reroute the signal from the XGA source at XGA INPUT 2 and AUDIO IN 2 to the XGA OUT and the AUDIO OUT connectors
No signal at all (that is, when there is no active input from a source at XGA INPUT 1 or at XGA INPUT 2), the WP-211DSwill still route XGA INPUT 2 and AUDIO IN 2 to the XGA OUT and AUDIO OUT connectors, and continue to examine XGA INPUT 1 input (when IN 1 is selected as the default), switching back to it when it detects a valid signal. Similarly, if the WP-211DSdetects no signal at all (when IN 2 is selected as the default), it will still route XGA INPUT 1 and AUDIO IN 1 to the XGA OUT and AUDIO OUT connectors, and continue to examine XGA INPUT 2 input, switching back to it when it detects a valid signal
1 Perhaps no source is connected, or that source is connected but its power is OFF
8 | KRAMER: SIMPLE CREATIVE TECHNOLOGY |
