Kenmore 790.479 manual Setting the Clock, Changing between 12 or 24 hour time of day display

Setting the Clock

Setting the Clock

The L--_ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day

operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "PF" (power failure, See Figure 1).

When PF appears in the display, press _. A beep will sound and PF will disappear.

INSTRUCTIONSPRESS

To set the clock (example below for 1:30)

1. Press		@.	"CLO"		will appear in the display (Figure 2).	@
2.	Press	(_	(_	_	pads to set the time of day to 1:30 (Figure	QQQ

3). Ptess ::iTARi:. The time of day will appear in the display(Figure

4).

Figure 1

DISPLAY

Figure 2

Figure 3

Changing between 12 or 24 hour time of day display

1.Press and hold L-_ for7 seconds. "CLO" and the current time of day will appear in the display (Figure 2). A beep will sound and "12h" (Figure 5) or "24h" (Figure 6) will appear in the display.

2.Press _n) to switch between the 12 and 24 hour time of day display. The display will show either "12h" (Figure 5) or "24h" (Figure 6).

@

for 7 seconds

@

Figure 4

Figure 5

3. Press : STAR_to'_accept the change or press _ to reject the :i!! or@ change.

4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.

Figure 6