TO REPLACE BELT
1.Install new belt over
motor drive, then over
belt pulley. | Motor |
NOTE: See | Drive |
| |
PARTS AND | Pu//ey |
| |
FEATURES | Agitator End Cap |
for belt num- |
|
ber. |
|
2. Place agitator assembly back into
3. Line up
|
| front | of |
|
| cover and | |
|
| base. | Rest |
|
| cover on | |
|
| front | edge of |
|
| base as | |
| Base | shown. | |
Cover |
|
| |
4. Rotate cover |
|
|
|
back. Press |
|
|
|
cover firmly until |
|
| |
side and rear |
|
|
|
tabs snap into |
|
|
|
place. |
|
|
|
Make sure there | Side | Rear |
|
is no gap | Latch | Latches |
|
between the cover and base.
5.Turn Power-Mate®upside down and replace two (2) cover screws.
t. Remove
BELT CHANGING AND
ING section.
Push In
And Turn
®cover as shown in
AGITATOR CLEAN-
2.Push in and turn bulb counterclock-
wise, then pull out to remove.
Push In | 3. Push in and turn | |
|
| |
And Turn | bulb clockwise, to | |
| replace. Bulb must | |
| not be higher | than |
| 15 Watts(130 | Volts). |
4. Reinstall
BELT CHANGING AND AGITATOR CLEAN- ING section.
NOTE: See PARTS AND FEATURES for
bulb number.
17