Kenmore 580. 72089 owner manual Removal from Window, Front Installation, Front lnstaflation

_ FRONT INSTALLATION

Install the front grille(packed separately) onto the cabinet as follows:

•Hook upper tabs of front grille into slots on the cabinet top° (FIG, 19)

o Push front gritle'stips towards the cabinet in order to snap side tabs into the cabinet, (FIG,,19)

•Open the inlet grille.,(FIG, 20)

•installthe screw (ITEM E) through the front grille. (FIGo20)

oCtese inlet grille. (FIG.,21)

Top of wood strip should be approximately 3/4" higher than the storm window frame to help condensation to drain properly to the outside

•Install a second wood strip (approximately 6" long by 1V2"wide and same thicknessas first strip) in the center of the outer sill flush against the back of the

inner sill Screw the L brackets into thisstrip This will raise the L bracket as shown in F1G 22,

		1 1/2" min
WOOD STRIP MOUNTED		(38ram)
ON TOP OF INNER	S_LL	__	--_-	3/4"
_L,				CLEARANCE V
J"	]	4 _	_	WINDOW
INNER	]L BRACKET			I FRAME

J	J	OUTER
l	I	S LL
INSIDE	1	OUTSIDE

Front lnstaflation FIG, 19

FIG, 22

REMOVAL FROM WINDOW

• Turn off and unplugthe air conditioner

. Remove the frontgrille, SeeHOWTO REMOVETHE FRONTGRILLE Referto page 13

. Unscrew the sidescrewsthatyou installed in Step 15

• Slidethe air conditionerout ef thecabinet,

BE CAREFULNOTTO DROPIT, Held onto it firmly the whole way slidingit out Once removed,set it safety out of the way

- Remove the L bracketfromwindowframeand the sash seal from betweenthe windows

Front Installation _.t• Unscrewthe sidecurtainsfromthe windowframe Fold themback to thesides of the cabinet

=Remove screwsattachingcabinetto inner sill Be careful not te tot cabinetfall once screwsareremoved

• Removecabinetfrom windowopening,

• Place air conditionerinto cabinet Reinstallside screws and Front Grille

• Place unit and all assemblyhardwarein air conditioner shippingcarton, and store in clean,dry place

Front installation FIG. 21

_IF AIR CONDITIONER IS BLOCKED BY

STORM WINDOW FRAME

,If storm windowpresents interference, fasten a 2'* wide wood strip to the inner window sill across the full width of the sill The wood strip should be thick

enough to raise the height of the window silt so that the unit can be installedwithout interference from the the storm window frame. See FfG 22

°Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit.

To prevent injury or strain, use proper lifting and carrying techniques when moving unit

•When handling the air conditioner, be careful to

avoid cuts from sharp metal fins on front and rear coils,,

•Make sure air conditioner does not fall during removal.

-8-