Kenmore 580. 75063 HOW to Insert Batteries, Into Remote Control, Remote Control Operations

REMOTE CONTROL			5, TIMER
			- SHUT-OFF TIME
Note: The Remote Control wilI not operate properly if			• You will usually use shut-off time while you sleep.
strong light shines on the sensor window of the Air			• With unit running, use Timer to set number of hours
Conditioner or if there are obstacles between the Remote			untiI shut-off.
Control and the Air Conditioner.			• For your steeping comfort, once Time is set, the
Every time you push button, you will hear beep sound			Temperature setting will raise 2F after 30 min, and
from the Air Conditioner.			2°F after another 30 min.
1	6	3	• Every time you push Timer button, it advances the
			Timer setting as follows: 1 Hour _ 2 Hours _ etc.
			12 Hours maximum.
			- START TIME
			• With unit not running, use timer to set number of
			hours before unit starts.
			• Every time you push Timer button, it advances the
4	2	5	Timer setting as follows: 1 Hour _ 2 Hours _ etc.
			12 Hours maximum

5

FIG. 15

REMOTE CONTROL OPERATIONS

1.POWER

•To turn the air conditioner ON, push this button. To turn the air conditioner OFF, push the button again.

•This button takes priority over any other button

•When you first turn it on, the unit is in cool mode, High fan speed, Temperature setting at 72T

2.TEMPERATURE SETTING

•Use this button to automatically control the temperature of the room.

The temperature can be set within a range of 60°F to 86"F by increments of I°F.

3.MODE

- Every time you push this button, it will shift among COOL, ENERGY SAVER and FAN.

- ENERGY SAVER

•The fan stops when the compressor stops cooling Approximately every 3 minutes the fan will turn on and

the unit wilt check the room air to determine if cooling is needed

4.FAN SPEED

•Every time you push this button, it advances the setting as follows: {High(F3) _ Low(F1 ) _ Med(F2) _ High(F3)}

-12-

HOW TO INSERT BATTERIES

INTO REMOTE CONTROL

1.Removethe cover from the back of the remote controller.

2.Insert two batteries

•Be sure that the (+) and (-) directions are correct

•Be sure that both batteries are new

3.Re-attach the cover

'_ .16

•Do not use rechargeable batteries. Such batteries differ from standard dry cells in shape, dimensions, and performance.

•Remove the batteries from the remote controller if the air

conditioner is not going to be used for an extended length of time.

•tn order to prevent discharge, remove the batteries from the remote control if the air conditioner is not going to be used for an extended period of time. Keep the remote control away from extremely hot or humid places. To maintain optimal operation of the remote control, the remote sensor should not be exposed to direct sunlight.

•The remote controI can be mounted on a wall using the mountable holder.

,)

FIG. 17