REMOTE CONTROL
INSERTING OR REPLACING THE BATTERIES - This remote control uses two AAA batteries.
∙Remove the back cover of the remote control.
∙Insert two “AAA” 1.5V batteries, making sure they are in the correct position (see instructions inside the battery compartment)
∙Replace the cover.
Do Not Mix Old And New Batteries. Do Not Mix Alkaline, Standard (Carbon - Zinc), or Rechargeable (Nickel - Cadmium) Batteries.
Dispose of old batteries properly. Do not leave batteries in the remote if it will not be used for longer than 2 months.
SOME IMPORTANT INFORMATION ABOUT USING THE REMOTE:
- The remote control needs to stay within 5 meters from the receiver on the appliance. Reception is confirmed by a beep from the main unit.
- The remote control will not operate if curtains, door or other material block the signal from the receiver to the remote control.
- Prevent any liquid from falling into the remote control. Do not expose the remote control to direct sunlight or heat- if the infrared signal receiver on the indoor unit is exposed to sunlight, the air conditioner may not function properly.
- If other electrical appliances react to the remote control, move them out of the way.
- When using the unit in out of room air conditioning mode point the remote control to signal box located in the window kit. Reception is confirmed by LED flash from the remote receiver kit.
- Do not store the remote control outside of the recommended temperature range of
9