Heat & Glo LifeStyle BAY-38HV Introducing the Heat-N-Glo Gas Fireplaces, Pre-install Preparation

Page 7

2Getting Started

Introducing the Heat-N-Glo Gas Fireplaces

Heat-N-Glo direct vent gas fireplaces are designed to oper- ate with all combustion air siphoned from outside of the building and all exhaust gases expelled to the outside.

The information contained in this Installers Guide, unless noted otherwise, applies to all models and gas control systems. Gas fireplace diagrams, including the dimensions, are shown in this section.

Pre-install Preparation

This gas fireplace and its components are tested and safe when installed in accordance with this Installers Guide. Report to your dealer any parts damaged in shipment, particularly the condition of the glass. Do not install any unit with damaged, incomplete, or substitute parts.

The vent system components are shipped in separate packages. The gas logs are stretch wrapped to the log grate. This stretch wrap must be removed before firing.

Read all of the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit. Failure to follow these instructions will void the owner’s warranty and may present a fire hazard.

The Heat-N-Glo Warranty will be voided by, and Heat-N-Glo disclaims any responsibility for, the following actions:

•Installation of any damaged fireplace or vent system component.

•Modification of the fireplace or direct vent system.

•Installation other than as instructed by Heat-N-Glo.

•Improper positioning of the gas logs or the glass door.

•Installation and/or use of any component part not manu- factured and approved by Heat-N-Glo, not withstanding any independent testing laboratory or other party approval of such component part or accessory.

ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE HAZARD.

When planning a fireplace installation, it’s necessary to determine:

•Where the unit is to be installed.

•The vent system configuration to be used.

•Gas supply piping.

•Electrical wiring.

•Framing and finishing details.

•Whether optional accessories—devices such as a fan, wall switch, or remote control—are desired.

If the fireplace is to be installed on carpeting or tile, or on any combustible material other than wood flooring, the fireplace should be installed on a metal or wood panel that extends the full width and depth of the fireplace.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents What to do if you smell gas Installers GuideSafety and Warning Information Table of Contents Standing Pilot Ignition DSI Ignition Service PartsDF-38HV-EP BAY-38HV Service Parts List / Liste des pièces de rechangeCertification High Altitude InstallationsInstallation Codes Appliance CertificationIntroducing the Heat-N-Glo Gas Fireplaces Pre-install PreparationANY Such Action MAY Possibly Cause a Fire Hazard Diagram of the BAY-38HV Clearance Requirements Fireplace Dimensions and LocationsConstructing the Chase Locating the FireplaceVertical and Horizontal Vent Runs Framing the FireplacePage Vent System Approvals Installing the Vent SystemIdentifying Vent Components Vent System Components and Termination KitsMAX .4 M Straight UP Vertical VentingStraight OUT Horizontal Venting Venting with Venting with ONE 1 90 ElbowONE 1 90 Elbow Venting with TWO Venting with TWO 2 90 Elbows Venting with Three 3 90 Elbows Venting with three 90 elbowsVenting with Three 3 90 Elbows Attach the First Vent Component to the Starting Collars Installing Vent ComponentsHole and Vent Pipe Install Support BracketsCeiling Firestop Ceiling Side Hole & New Framing MembersPointing UP Vent TerminationVent Termination Minimum Clearances =VENT Terminal =AIR Supply InletMinimum Height from Roof to Lowest Discharge Opening Gas Control Systems Positioning, Leveling, and Securing the FireplaceDSI Gas Pressure Requirements Gas Supply LineTo Check for GAS Leaks Wall Switch Wiring the FireplaceFor Standing Pilot Ignition Wiring Appliance Requirements Optional AccessoriesDirect Spark Ignition Wiring Diagram For Direct Spark Ignition DSI Wiring Appliance RequirementsSealant Material FinishingHearth Extensions Placing the Ember Material Installing Trim, Logs, and Ember MaterialInstalling the Trim Positioning the LogsBefore Lighting the Fireplace After the InstallationLighting the Fireplace Important Turn OFF the GAS Before Servicing Your Fireplace Fireplace Maintenance

BAY-38HV specifications

The Heat & Glo LifeStyle BAY-38HV is a cutting-edge gas fireplace designed to enhance the ambience of any home while providing efficiency and convenience. This innovative unit combines modern aesthetics with advanced technology, making it a popular choice among homeowners seeking both form and function in their heating solutions.

One of the standout features of the BAY-38HV is its sleek, contemporary design, which allows it to seamlessly integrate into various interior styles. With its clean lines and expansive viewing area, the fireplace creates a focal point in any room, offering a warm and inviting atmosphere. The heat-resistant glass front provides a clear view of the flames, ensuring that the beauty of the fire can be enjoyed from multiple angles.

In terms of technology, the BAY-38HV is equipped with the latest in gas fireplace innovations. It incorporates an advanced IntelliFire ignition system, allowing for easy operation with the simple push of a button. Users can control the flame height and heat output directly from a remote, providing complete convenience and customizability. This makes it an excellent option for those who want to adjust the ambiance of their space effortlessly.

Efficiency is another key characteristic of the BAY-38HV. The fireplace boasts a high efficiency rating, ensuring that the warmth generated is maximized while minimizing energy consumption. This efficient performance not only contributes to a more comfortable home but also helps in reducing heating costs, making it an environmentally friendly choice.

The BAY-38HV also features an array of customizable options, including various log styles and ember bed choices. This allows homeowners to tailor the appearance of their fireplace to suit their individual preferences. Additionally, its compatibility with zone heating systems offers an effective solution for those looking to heat specific areas of their home without relying on central heating.

Safety is paramount with the Heat & Glo LifeStyle BAY-38HV. It includes protective features such as a safety screen and automatic shut-off mechanisms, providing peace of mind for families and individuals.

In summary, the Heat & Glo LifeStyle BAY-38HV gas fireplace is an exemplary model that combines stylish design with advanced technology. Its ease of use, efficiency, customization options, and safety features make it an ideal choice for anyone looking to enhance their living space with the charm and comfort of a gas fireplace.
Top Page Image Contents