Heat & Glo LifeStyle BAY-38HV manual Safety and Warning Information

Page 2

SAFETY AND WARNING INFORMATION

!before starting the installation. FAILURE TO FOLLOW these installation instructions may result in a possible fire hazard and will void the warranty.

!Prior to the first firing of the fireplace, READ the Using Your Fireplace section of the Owners Guide.

DO NOT USE this appliance if any part has been under

!water. Immediately CALL a qualified service technician to inspect the unit and to replace any part of the control system and any gas control which has been under water.

!THIS UNIT IS NOT FOR USE WITH SOLID FUEL. Installation and repair should be PERFORMED by a

!qualified service person. The appliance and venting system should be INSPECTED before initial use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is IMPERATIVE that the unit’s control compartment, burners, and circulating air passageways BE KEPT CLEAN to provide for adequate combustion and ventilation air.

Always KEEP the appliance clear and free from

!combustible materials, gasoline, and other flammable vapors and liquids.

!NEVER OBSTRUCT the flow of combustion and ventilation air. Keep the front of the appliance CLEAR of all obstacles and materials for servicing and proper operations.

Due to the high temperature, the appliance should be

!LOCATED out of traffic areas and away from furniture and draperies. Clothing or flammable material SHOULD NOT BE PLACED on or near the appliance.

!Children and adults should be ALERTED to the hazards of high surface temperature and should STAY AWAY to avoid burns or clothing ignition. Young children should be CAREFULLY SUPERVISED when they are in the same room as the appliance.READ and UNDERSTAND all instructions carefully

!These units MUST use one of the vent systems described in the Installing the Fireplace section of the Installers Guide. NO OTHER vent systems or components MAY BE USED.

!This gas fireplace and vent assembly MUST be vented directly to the outside and MUST NEVER be attached to a chimney serving a separate solid fuel burning appliance. Each gas appliance MUST USE a separate vent system. Common vent systems are PROHIBITED.

!INSPECT the external vent cap on a regular basis to make sure that no debris is interfering with the air flow.

The glass door assembly MUST be in place and

!sealed, and the trim door assembly MUST be in place on the fireplace before the unit can be placed into safe operation.

DO NOT OPERATE this appliance with the glass door

!removed, cracked, or broken. Replacement of the glass door should be performed by a licensed or qualified service person. DO NOT strike or slam the glass door.

The glass door assembly SHALL ONLY be replaced

!as a complete unit, as supplied by the gas fireplace manufacturer. NO SUBSTITUTE material may be used.

DO NOT USE abrasive cleaners on the glass door

!assembly. DO NOT ATTEMPT to clean the glass door when it is hot.

!Turn off the gas before servicing this appliance. It is recommended that a qualified service technician perform an appliance check-up at the beginning of each heating season.

!Any safety screen or guard removed for servicing must be replaced before operating this appliance.

DO NOT place furniture or any other combustible

!household objects within 36 inches of the fireplace front.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Installers Guide What to do if you smell gasSafety and Warning Information Table of Contents Service Parts Standing Pilot Ignition DSI IgnitionBAY-38HV Service Parts List / Liste des pièces de rechange DF-38HV-EPAppliance Certification High Altitude InstallationsInstallation Codes CertificationANY Such Action MAY Possibly Cause a Fire Hazard Pre-install PreparationIntroducing the Heat-N-Glo Gas Fireplaces Diagram of the BAY-38HV Locating the Fireplace Fireplace Dimensions and LocationsConstructing the Chase Clearance RequirementsFraming the Fireplace Vertical and Horizontal Vent RunsPage Vent System Components and Termination Kits Installing the Vent SystemIdentifying Vent Components Vent System ApprovalsStraight OUT Horizontal Venting Straight UP Vertical VentingMAX .4 M ONE 1 90 Elbow Venting with ONE 1 90 ElbowVenting with Venting with TWO Venting with TWO 2 90 Elbows Venting with three 90 elbows Venting with Three 3 90 ElbowsVenting with Three 3 90 Elbows Installing Vent Components Attach the First Vent Component to the Starting CollarsInstall Support Brackets Hole and Vent PipeHole & New Framing Members Ceiling Firestop Ceiling SideVent Termination Pointing UP=VENT Terminal =AIR Supply Inlet Vent Termination Minimum ClearancesMinimum Height from Roof to Lowest Discharge Opening DSI Positioning, Leveling, and Securing the FireplaceGas Control Systems To Check for GAS Leaks Gas Supply LineGas Pressure Requirements Optional Accessories Wiring the FireplaceFor Standing Pilot Ignition Wiring Appliance Requirements Wall SwitchFor Direct Spark Ignition DSI Wiring Appliance Requirements Direct Spark Ignition Wiring DiagramHearth Extensions FinishingSealant Material Positioning the Logs Installing Trim, Logs, and Ember MaterialInstalling the Trim Placing the Ember MaterialLighting the Fireplace After the InstallationBefore Lighting the Fireplace Fireplace Maintenance Important Turn OFF the GAS Before Servicing Your Fireplace

BAY-38HV specifications

The Heat & Glo LifeStyle BAY-38HV is a cutting-edge gas fireplace designed to enhance the ambience of any home while providing efficiency and convenience. This innovative unit combines modern aesthetics with advanced technology, making it a popular choice among homeowners seeking both form and function in their heating solutions.

One of the standout features of the BAY-38HV is its sleek, contemporary design, which allows it to seamlessly integrate into various interior styles. With its clean lines and expansive viewing area, the fireplace creates a focal point in any room, offering a warm and inviting atmosphere. The heat-resistant glass front provides a clear view of the flames, ensuring that the beauty of the fire can be enjoyed from multiple angles.

In terms of technology, the BAY-38HV is equipped with the latest in gas fireplace innovations. It incorporates an advanced IntelliFire ignition system, allowing for easy operation with the simple push of a button. Users can control the flame height and heat output directly from a remote, providing complete convenience and customizability. This makes it an excellent option for those who want to adjust the ambiance of their space effortlessly.

Efficiency is another key characteristic of the BAY-38HV. The fireplace boasts a high efficiency rating, ensuring that the warmth generated is maximized while minimizing energy consumption. This efficient performance not only contributes to a more comfortable home but also helps in reducing heating costs, making it an environmentally friendly choice.

The BAY-38HV also features an array of customizable options, including various log styles and ember bed choices. This allows homeowners to tailor the appearance of their fireplace to suit their individual preferences. Additionally, its compatibility with zone heating systems offers an effective solution for those looking to heat specific areas of their home without relying on central heating.

Safety is paramount with the Heat & Glo LifeStyle BAY-38HV. It includes protective features such as a safety screen and automatic shut-off mechanisms, providing peace of mind for families and individuals.

In summary, the Heat & Glo LifeStyle BAY-38HV gas fireplace is an exemplary model that combines stylish design with advanced technology. Its ease of use, efficiency, customization options, and safety features make it an ideal choice for anyone looking to enhance their living space with the charm and comfort of a gas fireplace.
Top Page Image Contents