Heat & Glo LifeStyle EM-485T - 42 owner manual Glass Doors, Vented Gas Log Sets & Gas Log Lighters

Page 9

H. Glass Doors

•Glass doors are optional.

•Refer to Figure 2.2 for how to properly use them.

WARNING! Risk of Fire! Install ONLY doors ap- proved by Hearth & Home Technologies, Inc.

WARNING! Risk of Fire and Smoke! Fireplaces equipped with doors should be operated only with doors fully open or doors fully closed. If doors are left partly open, gas and fl ame may be drawn out of the fi replace opening.

FULLY OPEN

PARTLY OPEN

CORRECT

INCORRECT

FULLY CLOSED

PARTLY CLOSED

CORRECT

INCORRECT

Figure 2.2 Operating Positions of Bi-fold Doors

K. Vented Gas Log Sets & Gas Log Lighters

•Optional.

•Vented gas logs or gas log lighters can be installed in this fi replace. Follow the instructions provided with the accessory for operation.

WARNING! Risk of Fire or Asphyxiation!

•DO NOT install unvented gas logs.

•Damper must be locked open.

•Gas fl ame may generate fumes.

L. Optional Components

•Other options may be available

•Consult your dealer/distributor

WARNING! Risk of Fire! DO NOT install and or use any component not approved by Hearth & Home Tech- nologies Inc.

M. Clear Space

•Do not place combustible objects within 48 in. (1219 mm) of the front of fi replace. See Figure 2.3.

WARNING! DO NOT place combustible objects in front of the fi replace. High temperatures may ignite clothing, furniture or draperies.

•Mantel - avoid placing candles and other heat-sensitive objects on mantel or hearth. Heat may damage these objects.

I. Outside Air (optional)

The outside air kit supplies some fresh combustion air for your fi replace. It may help reduce the effects of negative air pressure. (See Section 5.D.)

•Refer to Figure 2.1 for location of control

•Close the inlet to prevent cold drafts when the fi replace is not being used.

CAUTION! Risk of Burns! The outside air control handle is HOT when fi replace is in operation. Adjust BEFORE lighting fi re.

J. Fan Kit (optional)

•Refer to instructions included with fan kit.

48 in. (1219 mm)

Clear Space

Front of Fireplace

Figure 2.3 Clear Space

12 in. (305 mm) Clear Space

Sides of Fireplace

(from the FP

opening)

Heat & Glo • EM-415, EM-485 • 33056 • Rev AF • 7/12

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Operation Wood Burning FireplaceHot screen/mesh and glass doors will cause burns Fire RiskListing Label Information/Location GrateNumber Table of Contents Installer GuideUser Guide Warranty Hearth & Home Technologies Inc Warranty Conditions Appliance Certification Listing and Code ApprovalsNon-Combustible Materials Combustible MaterialsOperating Instructions Your FireplaceHot glass will cause burns Starting a Fire Seasoned WoodGrate FirescreenVented Gas Log Sets & Gas Log Lighters Glass DoorsOptional Components Clear SpaceHardwood vs Softwood Wood FuelMaintenance and Service Chimney Inspection/CleaningDisposal of Ashes Check Firebox Refractory Glass CleaningInspect Grate Frequency As desiredStart Fire Problems Possible Cause Solution Troubleshooting GuideTypical Fireplace System Getting StartedDesign and Installation Considerations DraftNegative Pressure Frequently open doors Central heat outlets or returns Locating Fireplace & ChimneyInspect Fireplace and Components Tools and Supplies NeededConfigurations Fireplace Dimensions .A 1219 mm MinimumFraming & Clearances Select Fireplace LocationClearances to Combustible Materials ClearancesFrame the Fireplace Sidewalls/SurroundsThings to Consider Installation of FireplacePosition the Fireplace Place Protective Metal Hearth StripsFt min. from top of uppermost chimney section to air inlet Junction Box Installation Install Outside Air KitPrepare Junction Box Bracket Installation of FanMaintain minimum height of chimney above roof Chimney AssemblyHeight of Chimney Components Chimney RequirementsExample Using Offsets/ReturnsInstall Chimney Air Kit Installing Ceiling FirestopsAssembling Chimney Sections Prepare Attic Insulation Shield Installing Attic Insulation ShieldComplete Installation Install FlashingCut out Hole in Roof Flat Roofs Chimney Termination RequirementsConstruct the Chase Chase InstallationsGas line holes and other openings should be caulked with Chase should be constructed in the manner of allInstall Chase Top Install Fireplace & ChimneyST375 Square Termination Cap Install Termination CapTCT375 Terra Cotta Cap TS345/TS345P Square Termination CapShrouds Radiation ShieldField Constructed Shrouds Mailbox Style Shroud radiation shield required Finishing Hearth Extension= 1/k x inches of thickness Non-combustible Facing Finishing MaterialGrid represents 1 in. scale Combustible MantelInstall Fan AccessoriesGas Log/Lighter Provision Wood Burning InsertsReference Materials Catalog # Description Fireplace Components1321 mm 406 mm Catalog # Chimney Components10-1/2 267 mm Effective Outside Height Diameter 10-1/2 121 mm 267 mm305 mm 27-3/8 24-5/8 695 mm 625 mm 305 mm 24-5/8 625 mm 787 mmDTO134 a 10-7/8 276 mm In. Starter Section Assembly 22069B Top Standoff Service PartsStocked At Depot29245 Traditional Brick Back Refractory29992 Traditional Brick Side Refractory 28393 Traditional Brick Hearth RefractoryEM-485T Traditional Refractory Do not Discard this Manual

EM-485T - 42, EM-415 - 36 specifications

Heat & Glo has established itself as a leader in innovative fireplace solutions, and the LifeStyle series, particularly the EM-415 and EM-485T models, showcases the brand's commitment to quality, efficiency, and design flexibility. These gas fireplaces are designed to seamlessly blend into any living space, providing not just warmth but also a stylish focal point.

The EM-415, with its 36-inch firebox, and the EM-485T, featuring a generous 42-inch firebox, deliver a stunning visual experience. Both models boast a contemporary design that enhances the aesthetics of modern homes. The clean, linear appearance is complemented by a large viewing area, allowing for an unobstructed view of the flames.

In terms of technology, Heat & Glo incorporates advanced features such as Intellifire™ Ignition System, which allows for reliable and safe start-up while ensuring energy efficiency. This system also includes the option for remote control operation, providing added convenience for users. The fireplaces can be easily adjusted to suit individual comfort levels, with variable flame settings that allow for customizable heat output.

Additionally, both models utilize the latest in heat management technology. The Heat & Glo LifeStyle series is designed with excellent insulation, promoting better heat retention and minimizing heat loss. This not only enhances the efficiency of the fireplace but also contributes to overall energy savings.

Safety is paramount in the design of the EM-415 and EM-485T. They are equipped with standard safety features such as an automatic shut-off system, ensuring peace of mind while the fireplace is in use.

Moreover, the versatility of these models is highlighted by their ability to be installed in various settings, including walls and corners. The option for different media, such as glass or stone, allows homeowners to personalize their fireplace, making it a perfect fit for any decor style.

Overall, the Heat & Glo LifeStyle EM-415 and EM-485T gas fireplaces represent a fusion of aesthetics, technology, and safety, making them an ideal choice for anyone looking to enhance the comfort and style of their home. With their range of features and design options, these models are sure to create a warm and inviting atmosphere for years to come.
Top Page Image Contents