GN National Electric PV-28SV50, PV-28SV55, GN Installation Instructions General Safety Information

Page 18

INSTALLATION INSTRUCTIONS - GENERAL SAFETY INFORMATION

1.This installation must conform with local codes or, in the ab- sence of local codes with NFPA54.

2.Provide adequate clearances around the product for servic- ing and ensure there are no obstructions to the combustion air intake situated at the back of the heater. Refer to Page 15, Figures 7 and 11.

3.The appliance must be installed on a flat, solid continuous surface (i.e. wood, metal, concrete). Please Note: Rough or uneven surfaces can cause vibration or humming in the heat- er.

4.The Mantis Power-Vent High-Effeciency Fireplace can be in- stalled in a wide variety of ways and will fit nearly any room layout. It may be installed in a recessed position, framed out into the room, or across a corner. For installation options re- fer to page 15.

5.This appliance (Insert and Freestanding Models) needs to be installed in such a way that the heater can be removed at all times to service the heater exchanger and flue fan located in the rear section of the heater.

Note: Under no circumstances should the appliance be in- stalled under conditions which would not allow for easy removal of the appliance to carry out routine inspection and service to the appliance, to do so will void the warranty.

Note: On Single Wall flue pipe installations (imitation zero clearance fireplace) a minimum of 2” (50.8cm) clear- ance must be provided at the rear of the heater to enable the heater to get sufficient combustion air to the air inlet located at the rear of heater. Refer to installation instruc- tions on page 15, Figures 7 and 9.

Note: Where a mantel surround is being used on insert installa- tions and zero clearance fireplace installations, the com- bustion air intake slot located in the top mantel surround must have no obstructions to allow combustion air to en- ter through the slot to the combustion air inlet located at the back of the heater.

Page 18

22618-4-1106

Image 18
Contents Installation Instructions Table of Contents Important Safety Information This is a Heating ApplianceSafety Information for Users of LP-GAS LP-GAS Warning OdorRequirements for Massachusetts Vent Directly BELOW. Keep Clear of ALL ObstructionsGAS Supply Installing a New Main Gas CockPressure Testing of the Gas Supply System Recommended Gas Pipe DiameterIntroduction Specifications AccessoriesClearances for Direct Vent Heater Installation for Direct VentInstallation on Rugs and Tile Locating Wall OpeningHeater Installation for Single Flue Clearances for Single FlueHeater with Pedestal and Single Flue Adaptor Specifications Heater without PedestalFireplace Insert with Mantel surround with slim top panel Flue Outlet Electric Cord 8 BSP Connection Inside SurroundFireplace Insert with Mantel Surround with short top panel Clearance to Combustibles Freestanding UnitsLOG SET Installation Instructions Log InstallationAll Logs LOG SET Diagram a Installation Instructions General Safety Information Vent Examples for Single Flue Vent Examples for Single Flue Single Flue Vertical Vent RunFlex Vent Tubing Venting for Existing Fireplace Installation Determining Minimum Vent Height Above the RoofHorizontal Venting Direct Vent Installation InstructionsDirect Vent System Building Exterior View Maximum Horizontal Venting 47 1/2 1.2mMinimum Exterior Grade Dimension Unit Without Pedestal Minimum Exterior Grade Dimension Unit With PedestalDirect Vent Installation Instructions GAS Connection Installation Instructions GAS Connection Line SupplyOperating Instructions Checklist Lighting Instructions For Your Safety Read Before Lighting FAN Operation GAS Conversion Instructions Conversion Instructions from LP Propane GAS to Natural GASConversion Instructions from Natural GAS to LP Propane GAS Automatic Humidifier Operation Optional Remote Control Thermostat Thermostat Display ModeWiring Wiring DiagramGeneral Information MaintenanceOver Temperature Cut Out Paint Curing First FiringMain Burner Drawing Cleaning Main Burner Front door removal drawing Glass CleaningGlass Assembly Replacement General Glass InformationUnit Operating Faults Resetting the HeaterLOG Placement Main Convection FANHeat Exchanger Surround Installation Instructions Parts ListPedestal Installation Instructions Optional Pedestal Assembly InstallationParts List Index Part Number DescriptionGAS Line Front Parts View 7368 Warranty Terms Purchase Date Dealer Name/PhoneHOW to Order Repair Parts Service Notes