Fireplace
Installation
Continued
Installing Optional Brick liner Model BL32D
WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local retailer or see Acces- sories, page 39.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Excessive force will break brick panels.
1.Remove top and bottom louvers to allow ac- cess to door latches.
2.Remove screen, unlock door latches and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, page 23.
3.If installing brick liner in new fireplace, go to step 4. If installing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.
4.Remove three screws from deflector shield on the inside top of firebox. Set shield and screws aside.
5.Install rear brick panel first. Rest bottom edge of panel on back edge of grate (see Figure 39).
Rear Brick
Panel
Figure 39 - Installing Rear Brick Panel
6.Install left side brick panel by sliding it between grate and side of firebox (see Figure 40).
7.Install the right brick panel using the same method described
8.Replace deflector shield using screws removed in step 4.
9.Install logs, lava rock, and ember material see Installing Logs, Lava Rock and Glowing Embers.
10.Close glass door, lock latches on top and bottom of door and replace screen (see Removing/Re- placing Glass Door, steps 5 and 6, page 23).
11.Close top and bottom louvers.
Left Side
Brick Panel
Figure 40 - Installing Side Brick Panels
Installing logs, lava rock and glowing embers
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See Removing/Replacing Glass Door, steps 1 and 2, page 23. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (rear log) on top of grate. Make sure notches in bottom of log fit over grate (see Figure 41, page 25).
2.Rest log #2 (front log) on pins on front part of grate (see Figure 42, page 25).
3.Place log #3 (crossover log) onto rear and front logs. Make sure it is seated properly on smooth surface of front log and pin on back log as shown in Figure 43, page 25.
24 | www.desatech.com |