Installing Logs, Installing One Piece Log Set

OWNER’S MANUAL

INSTALLATION

Continued

INSTALLING LOGS

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: Do not remove the warning and instruction lables attached to the heater base as- sembly. These markings contain important warranty information.

WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flame contact any log. If so, repo- sition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

It is very important to install the logs exactly as instucted. Do not modify logs. Only use logs supplied with heater.

1.Place one-piece log set on grate to fit as illustrated in Figure 23. Make sure middle section at bottom of log set is seated into "U"-shaped cutout in cen- ter of chassis (see Figure 24).

IMPORTANT: Make sure log does not cover any burner ports.

2.Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 25).

WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.

One Piece

Log Set

Middle

Section at

Bottom of

Log Set

Burner

"U"-shaped

ChassisCutout in Chassis

Figure 22 - Installing One Piece Log Set

Burner Ports

One Piece Log Set

Figure 23 - Installing One Piece Log Set (Top View)

Notches

Screws for

Mounting Screen

Figure 24 - Installing Fireplace Screen

104352