OWNER’S MANUAL
PRODUCT
IDENTIFICATION
One Piece Log Set
Optional Remote
Control
| IH |
|
| L |
|
Control |
| O |
NO | F | |
F | ||
| OT P | |
Knobs |
|
|
Piezo
Ignitor Remote Selector
Switch (Optional)
Figure 1 - Log Base Assembly
Top Outer
Casing
Top Louver
Assembly
Firebox
Hood
Firebox
Support
Screen
Assembly
Figure 2 - Fireplace | Bottom Louver | Blower Assembly |
Assembly | (Optional) |
LOCAL CODES
Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.
2.Locate two screws above top corners of the fireplace screen. Remove and discard these screws. Lift fireplace screen up and pull out to remove.
3.Remove protective packaging applied to logs, log base assembly, and fire- place.
4.Remove fireplace hood from carton insert.
5.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought fireplace.
REMOTE CONTROL ACCESSORIES
There are four optional remote controls that can be purchased separately for this log heater:
•wall switch
•wall thermostat
•hand held ON/OFF remote
•hand held thermostat remote
See Accessories, pages 22 and 23.
104352 | 3 |