VANGUARD
UNVENTED
INSTALLATION
Continued
INSTALLING FIREPLACE
SCREEN
1.Insert each rod through all rings located at top of screen.
2.Insert first rod into rear hole in left side of firebox. Fasten rod to rear hole near center of firebox using #10 x 3/8" Phillips screw provided.
3.Insert other rod into front hole on right side of firebox and fasten using remain- ing Phillips screw.
Top View of Rod Layout
Screw
Rear Hole
Front Hole
Rod
Ring
Screen
Figure 21 - Installing Fireplace Screen (Models FB36CA and FB42C Shown)
TECHNICAL
SERVICE
You may have further questions about in- stallation, operation, or troubleshooting.
If so, contact DESA International’s Techni- cal Service Department at
REPLACEMENT PARTS
Note: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty.
Parts Under Warranty
Contact authorized dealers of this product. If they can’t supply original replacement part(s), call DESA International’s Techni- cal Service Department at
When calling DESA International, have ready
•your name
•your address
•model number of your firebox
•how firebox was malfunctioning
•type of gas used (propane or natural gas)
•purchase date
Usually, we will ask you to return the defec- tive part to the factory.
Parts Not Under Warranty
Contact authorized dealers of this product. If they can’t supply original replacement part(s), call DESA International’s Parts Department at
When calling DESA International, have ready
•model number of your firebox
•the replacement part number
Note: The firebox identification label (in- cluding model number, serial number, clear- ances, etc.) is located behind the left side firebrick panel. See Figure 15, page 10.
12 | 103451 |