Desa (V)T36P SERIES, (V)T32P installation manual For Your Safety, What to do if YOU Smell GAS

Page 1

DIRECT-VENT FIREPLACE

OWNER’S OPERATION AND INSTALLATION MANUAL

NATURAL GAS “TUDOR” MODEL

(V)T32N, (V)T36N SERIES, CHDV32NR, CTDV36NR

PROPANE/LP GAS “TUDOR” MODEL (V)T32P, (V)T36P SERIES

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch

Do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

INSTALLER: Leave this manual with the ap- pliance

CONSUMER: Retain this manual for future reference.

WARNING: Improper installation, adjust- ment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual for correct installation and operational procedures. For assistance or additional information consult a qualified in- staller, service agency, or the gas supplier.

Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

This appliance is only for use with the type of gas indicated on the rating plate. This ap- pliance is not convertible for use with other gases, unless a certified kit is used.

This appliance may be installed in an after- market*, permanently located, manufactured (mobile) home, where not prohibited by state or local codes.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer.

For more information, visit www.desatech.com

Image 1
Contents What to do if YOU Smell GAS For Your SafetySafety Information Table of ContentsProduct Identification Local Codes Product FeaturesLocation and space requirements Pre-Installation PreparationClearances 23 1 Framing and finishingTermination CAP AIR Supply Inlet GAS Meter Location of Termination CapInstallation Precautions Venting Installation InstructionsInstallation Planning Horizontal Termination InstallationVent Pipe Connections Installing Siding Standoff Square Termination Horizontal Termination ConfigurationsVenting with Two 90 Elbows Snorkel Termination InstallationOffset with Wall Strap and 45 Elbows Flat Ceiling InstallationVertical Venting Vertical Termination ConfigurationsHigh Altitude Installation Fireplace InstallationParts lists for venting kits and components Installing optional blower accessoriesBlower Model BK Model BKT InstallationBlower Wiring Diagram Installing Gas Piping to Fireplace LocationInstallation Items Needed Installation Items Needed Connecting Fireplace to GAS SupplyPressure Testing Fireplace Gas Connections Pressure Testing Gas Supply Piping SystemChecking GAS Connections Test Pressures In Excess Of 1/2 Psig 3.5 kPaAttaching Alkaline Battery to Receiver Installing Remote ReceiverRemoving/Replacing Glass Door Cleaning Glass DoorRemoving Louver Panels Removing Glass DoorInstalling Log No Installing logs, lava rock and glowing embersInstalling Logs No and No Manual Lighting Procedure For your safety read Before lightingOperating Fireplace Lighting InstructionsRemote Operation OpTIONAL Hand-HeldThermostat Series Model HRC200 On/Off Series Model HRC100Pilot assembly Operating optional blower accessoryInspecting Burners Operating optional GWMT1 Wall Mounted ThermostatGlass Door Cleaning MaintenancePilot and burners LogsTo clean pilot. This can damage pilot unit TroubleshootingTroubleshooting Above Gas leak. See Warning statementService Hints Replacement PartsTechnical Service SpecificationsAccessories CHDV32NR Illustrated Parts BreakdownParts List CTDV36NR Parts List Keep this Warrant Warranty Information