Desa (V)T36P SERIES, (V)T32P Installing Remote Receiver, Attaching Alkaline Battery to Receiver

Fireplace Installation

Continued

Installing Optional Wireless hand- held REMOTE CONTROL - HRC100 and HRC200 Series

NOTICE: Use only alkaline batteries (not included).

Installing Remote Receiver

1.Open bottom louver and locate the switch bracket on the left.

2.Unscrew the switch bracket. Lean bracket forward so you are able to access the back of the remote receiver.

3.Locate the battery clip mounted on the back of the receiver. Slide a 9-volt alkaline battery (not included) through the clip (see Figure 36).

4.Attach the terminal wires to the battery.

5.Remove wire from TH to TPTH on control valve (see Figure 37).

6.Connect wires from receiver to TH and TPTH to control valve (see Figure 38).

7.Replace the switch bracket.

Receiver
9-Volt	Terminal
Alkaline
Battery	Wires
	Battery Clip

Figure 36 - Attaching Alkaline Battery to Receiver

To Optional

Remote

Accessory

Installing 9-Volt Alkaline Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to a 9-volt alkaline battery (not included). Place battery into the battery housing.

3.Replace battery cover onto remote control unit.

Battery Cover	Remote Control Unit
Terminal
Wires

Battery

9-VoltHousing

Battery

Figure 39 - Installing Alkaline Battery in Hand-Held Remote

Control Unit

Figure 37 - Disconnecting TH	Figure 38 - Control Valve
to TPTH Wire	Terminals

108661-01F www.desatech.com 19