OWNER’S MANUAL
INSTALLATION
Continued
CHECKING GAS
CONNECTIONS
WARNING: Test all gas pip- ing and connections for leaks after installing or servicing. Cor- rect all leaks at once.
WARNING: Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once.
Pressure Testing Gas Supply Piping System
Test Pressures In Excess Of 1/2 PSIG
1.Disconnect fireplace and its individual manual shutoff valve from gas supply piping system. Pressures in excess of 1/2 psig will damage fireplace regulator.
2.Cap off open end of gas pipe where manual shutoff valve was connected.
3.Pressurize supply piping system by ei- ther using compressed air or opening main gas valve located on or near gas meter.
4.Check all joints of gas supply piping system. Apply mixture of liquid soap and water to gas joints. Bubbles form- ing show a leak.
5.Correct all leaks at once.
Test Pressures Equal To or Less Than 1/2 PSIG
1.Close manual shutoff valve (see Figure 19).
2.Pressurize supply piping system by ei- ther using compressed air or opening main gas valve located on or near gas meter.
3.Check all joints from gas meter to manual shutoff valve (see Figure 20). Apply mixture of liquid soap and wa- ter to gas joints. Bubbles forming show a leak.
4.Correct all leaks at once.
Pressure Testing Fireplace Gas Connections
1.Open manual shutoff valve (see Fig- ure 19).
2.Open main gas valve located on or near gas meter.
3.Make sure control knob of fireplace is in the OFF position.
4.Check all joints from manual shutoff valve to thermostat gas valve (see Fig- ure 20). Apply mixture of liquid soap and water to gas joints. Bubbles form- ing show a leak.
5.Correct all leaks at once.
6.Light fireplace (see Operating Fire- place, pages 14 and 15). Check all other internal joints for leaks.
7.Turn off fireplace (see To Turn Off Gas to Appliance, page 15).
8.Replace front panel.
Open
Manual
Shutoff
Valve
PCO losed
Figure 19 - Manual Shutoff Valve
Manual
Shutoff
Gas Meter Valve
Figure 20 - Checking Gas Joints
INSTALLING 9-VOLT BATTERY FOR WIRELESS REMOTE CONTROL
Two
Installing 9-Volt Battery in Receiver
1.Locate back of receiver located at the bottom, left side of the heater base.
2.Locate the battery clip mounted on the back of the receiver.
3.Slide a
4.Attach the terminal wires to the battery.
Receiver
Terminal
Wires
Battery Clip
Figure 21 - Attaching Battery to Receiver
Installing 9-Volt Battery in Hand- Held Remote Control Unit
1.Remove battery cover on back of re- mote control unit.
2.Attach terminal wires to the battery. Place battery into the battery housing.
3.Replace battery cover onto remote con- trol unit.
Battery Cover Remote Control Unit
Terminal
Wires
Battery Housing
Figure 22 - Installing Battery in Hand- Held Remote Control Unit
104326 | 13 |