CGCF26NR
VENT-FREE NATURAL GAS COMPACT FIREPLACE
ASSEMBLY
WARNING: Always have branch support and screen in place before operating fireplace. This prevents excessive tempera- tures on fireplace surfaces.
ASSEMBLING FIREPLACE
Tools Required:
•Phillips screwdriver
•5/16" hex wrench
•Slotted screwdriver
Installing Log
1. | Remove back log, branch, and hood from |
| log box. Discard protective packaging. |
2. | Remove two shipping screws above |
| screen (see Figure 2). |
3. | Lift screen up and pull out to remove. |
4. | An optional blower is available. See Ac- |
| cessories, page 21. Install optional |
| blower now. Follow installation in- |
| structions provided with blower. |
5. | Gently place back log on burner sup- |
| port (see Figure 2). The log should fit |
| flat against top of burner support. Place |
Screen Shipping Screw
Shoulder Screw
Back Log 
Burner
Support
Screw
Branch
Branch Support
Screw
Screen
Figure 2 - Assembling Fireplace
two #10 |
burner support into the log and tighten. |
Place branche on branch support (see |
Figure 2). |
6. Do not allow branch to contact flame. |
If flame contacts branch, soot will be |
created. |
7. Reattach screen by placing notches in |
screen frame over shoulder screws and |
pushing down. |
Assembling Hood
1.Locate four
2.Remove two 13/4" screws from under- neath middle rail (see Figure 3).
3.Slip top of hood between middle rail and top of firebox wrapper (see Figure 3).
4.Reinstall two 13/4" screws removed in step 2. Make sure screw pass through hood and middle rail and attach into upper louver assembly (see Figure 3).
5.Attach four
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this fireplace may result in propertydamageorpersonalinjury.
Middle Rail
Hood
Firebox Top
2 Short
Screws
1 3/4" Screws
Figure 3 - Assembling Hood
4 | 104326 |