Desa H) AND VM42E(B Introduction, Before YOU Begin, M36EB,H/VM36EB,H M42EB,H/VM42EB,H

Page 4

4

INTRODUCTION

Before You Begin

INTRODUCTION

Models M36E(B,H), VM36E(B,H), M42E(B,H) and VM42E(B,H) are vented gas fireplaces that use an electronic gas control valve and electronic ignition system. A 6" B-Type venting system and a listed type vent cap are not supplied but are required for proper operation. See venting instructions on pages 9 and 10.

WARNING: This gas appliance must not be con- nected to a chimney flue servicing a solid fuel burn- ing appliance.

Models M36E(B,H), VM36E(B,H), M42E(B,H) and VM42E(B,H) are factory equipped for use with natural gas and must be converted when intended for use with propane/LP gas. A respective model PCBE-36 or PCBE-42 conversion kit may be purchased for simple conversion to propane/LP gas. See Accessories, page 25.

BEFORE YOU BEGIN

Before beginning the installation of your appliance, read these instructions through completely.

This DESA appliance and its approved components are safe when installed according to this installation manual and are operated as recommended by DESA. Unless you use DESA approved components tested for this appliance, YOU MAY CAUSE A FIRE HAZARD!

The DESA warranty will be voided by, and DESA disclaims any responsibility for the following actions :

A)Modification of the appliance or any of the components.

B)Use of any component part not approved by DESA in combi- nation with this appliance.

C)Installation and/or operation in a manner other than instructed in this manual.

D)The burning of anything other than the type of gas approved for use in this gas appliance.

The installation must conform with local codes or, in the absence of local codes, with the current National Fuel Gas Code, ANSI Z223.1 or with the current CAN/CGA B149 Installation Codes.

This appliance complies with ANSI Z21.50-2000and CSA 2.22- 2000 as Vented Gas Fireplaces and is listed and tested by the Canadian Standards Association to the above test standards.

WARNING: Installation of this appliance should be done by a qualified service person well trained in the installation of such appliances. You will also need a building permit from your local Building and Safety Commissioner before installing this appliance; other- wise your insurance co. may not cover this appliance.

NOTICE: This appliance is not intended to be used as a primary source of heat.

CAUTION: Do not connect appliance before pres- sure testing gas piping. Damage to gas valve may result and an unsafe condition may be caused.

The appliance and it’s individual shutoff valve must be discon- nected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa).

The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa).

For the purpose of input adjustment two pressure taps (for IN and OUT pressures) are provided on the gas control valve for test gauge connections to the appliance.

GAS RATING - NATURAL

 

M36E(B,H)/VM36E(B,H)

M42E(B,H)/VM42E(B,H)

Max. Input Rating:

40,000 Btu/Hr

45,000 Btu/Hr

Manifold Pressure:

3.5 in. WC (.87 kPa)

3.5 in. WC (.87 kPa)

Minimum Supply Pressure:

4.5 in. WC (1.12 kPa)

4.5 in. WC (1.12 kPa)

Maximum Supply Pressure:

10.5 in. WC (2.66 kPa)

10.5 in. WC (2.66 kPa)

 

 

 

Orifice Size:

# 30

# 29

 

 

 

GAS RATING - PROPANE/LP

Max. Input Rating:

40,000 Btu/Hr

 

45,000 Btu/Hr

 

 

Manifold Pressure:

10.0 in. WC (2.49 kPa)

 

10.0 in. WC (2.49 kPa)

 

Minimum Supply Pressure:

11.0 in. WC (2.74 kPa)

 

11.0 in. WC (2.74 kPa)

 

Maximum Supply Pressure:

13.0 in. WC (3.23 kPa)

 

13.0 in. WC (3.23 kPa)

Orifice Size:

# 51

 

# 47

 

 

 

 

 

 

 

 

For more

visit www.

.com

108796-01D

Image 4
Contents For Your Safety Vent Decorative GAS FireplaceElectronic Ignition Natural GAS What to do if YOU Smell GASTable of Contents Safety InformationUnpacking Before YOU Begin IntroductionM36EB,H/VM36EB,H M42EB,H/VM42EB,H Product Specifications ModelSelecting Location PRE-INSTALLATION PreparationClearances Mantel Clearances and Wall Details M36EB,H M42EB,HVM36EB,H VM42EB,H M36EB,H M42EB,H VM36EB,H VM42EB,HInstalling Transition Pipe and Starter Collar FramingVenting Installation Typical B-Vent ConfigurationChecking for Proper Venting Min Roof PitchInstallation Wall Switch InstallationOptional Remote Control GAS Line HOOK-UPEmber and PAN Material Placement OvertightenLOG Placement for M36E/VM36E Models Installing Logs 1LOG Placement for M42E/VM42E Models Installing Logs 1A, 1BCombustion AIR KIT Model AK4 Optional Installing Optional Glass Door AccessoryAppliance Enclosure Opening Vent Damper DoorFor Your Safety Read Before Lighting Operating FireplaceLighting Instructions To Turn OFF GAS To ApplianceCleaning Maintenance Inspecting BurnersService Hints Technical ServiceWiring Diagram Replacement PartsTroubleshooting Observed Problem Possible Cause RemedyTop Gas leak. See Warning statement atIllustrated Parts Breakdown VM42EB,H ModelsParts List VM36EB/VM42EBLogs for M36EB,H,M42EB,H, VM36EB,H and VM42EB,H Models Logset for M36EB,H and VM36EB,H ModelsAccessories Warranty Information

M36E, M42E, VM36E, VM42E, H) AND VM42E(B specifications

Desa M36E, M42E, VM36E, VM42E(H), and VM42E(B) are advanced heating solutions engineered for enhanced performance and versatility in both residential and commercial settings. These models stand out for their efficient heating capabilities and innovative designs, which cater to a variety of heating needs.

The Desa M36E and M42E models offer a robust heating output, making them ideal for larger spaces. The M36E boasts a compact structure that accommodates small to medium areas, while the M42E provides greater output suitable for bigger rooms. Both units are equipped with high-efficiency burners that ensure optimal fuel utilization, leading to significant cost savings over time.

The VM36E and VM42E(H) models take efficiency to the next level. Their advanced combustion technology maximizes heat production while minimizing emissions, aligning with modern environmental standards. The VM36E features a versatile design, allowing it to seamlessly integrate into various décor styles, while providing a steady flow of warm air. Meanwhile, the VM42E(H) is enhanced with a hybrid heating system, enabling users to switch between energy sources, which adds to its adaptability in differing climates or situations.

The VM42E(B) model introduces an innovative breakthrough in heating technology by incorporating smart control features. Users can effortlessly regulate their heating preferences through a smartphone application, allowing for remote management and programming based on individual schedules. This smart technology not only enhances user convenience but also supports energy conservation by promoting efficient usage patterns.

All models come equipped with safety features such as automatic shut-off mechanisms, ensuring peace of mind during operation. The units are designed with durable materials, capable of withstanding prolonged use while maintaining aesthetic appeal.

In summary, Desa's M36E, M42E, VM36E, VM42E(H), and VM42E(B) represent the forefront of modern heating solutions, combining high efficiency, innovative technologies, and user-friendly features. Their diverse applications, coupled with intelligent design, ensure they meet the evolving demands of today's consumers while providing warmth and comfort in any setting.