Desa VSGF36NR, VSGF36PR installation manual Operating Fireplace, Lighting Instructions

Page 19

OPERATING FIREPLACE

THERMOSTAT MODELS

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, donʼt try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING

INSTRUCTIONS

WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is installed before running fireplace.

NOTICE: During initial operation of new fireplace, burning logs will give off a paper-burning smell. Orange flame will also be present. Open window to vent smell. Operate fireplace on HI position to burn off odor. This will only last a few hours.

1.STOP! Read the safety information, column 1.

2.Make sure equipment shutoff valve is fully open.

3.Turn control knob clockwise to the OFF position (see Figure 26).

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information, column 1. If you donʼt smell gas, go to the next step.

5.Turn control knob counterclockwise to the PILOT position. Press in control knob for five (5) seconds (see Figure 26).

Note: If running fireplace for first time, there will be air in gas line. You may need to press in control knob for 30 seconds or longer. This will allow air to bleed from the gas system.

6.Continue pressing control knob in. Press and release ignitor button. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.

Ignitor Button Control Knob

Figure 26 - Control Knob and Ignitor

Button Location

113192-01D

www.desatech.com

19

Image 19
Contents What to do if YOU Smell GAS Table of Contents Safety Information Local Codes Product Identification Product FeaturesUnpacking Locating Firebox Product SpecificationsPlanning Confined and Unconfined Space AIR for Combustion VentilationProviding Adequate Ventilation Unusually Tight ConstructionDetermining if You Have a Confined or Unconfined Space Determining FRESH-AIR Flow for Heater LocationVentilation Air From Outdoors InstallationVentilation AIR Ventilation Air From Inside BuildingMinimum Wall and Ceiling Clearances see Figure Installation ClearancesMantel Clearances for Built-In Installation BUILT-IN Firebox InstallationRough Opening Dimensions for Built-in Installation Installing GAS Piping to Fireplace Location Installing Firebox Using Optional Accessory MantelsNatural Gas Installation Items NeededPropane/LP Removing Log Base Assembly From Fireplace Connecting Fireplace to GAS SupplyTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Groove Installing Fireplace Hood and Screen HARD-WIRING FireboxOperating Fireplace Thermostat Models For Your Safety Read Before LightingLighting Instructions Thermostat Control Operation Manual Lighting ProcedureRemote Control Models For Your Safety Read Before Lighting To Turn OFF GAS To ApplianceSet flame adjustment knob to any level between HI and LO Shutting Off Heater Blower OperationOptional HAND-HELD Remote Operation ON/OFF Series Model GhrcbTurns Manual ModeAuto Shutoff Feature Thermostat Series Model GhrctbMain Burner Key Pad Lock FeatureInspecting Burners Pilot Flame PatternBurner Injector Holder and Pilot AIR Inlet Hole Cleaning MaintenanceService Hints Wiring Diagram Replacement PartsSpecifications Technical ServiceObserved Problem Possible Cause Remedy TroubleshootingDiagram, See Cleaning and Mainte Shut off gas supply Do not try to light any appliance Accessories Models VSGF36PT, VSGF36NT Illustrated Parts BreakdownParts List Models VSGF36PR, VSGF36NR KEY Part Number VSGF36PR VSGF36NR Description QTY Models VSGF36PT, VSGF36NT, VSGF36PR and VSGF36NR KEY Part Number Description QTY 113192-01D 113192-01D Keep this Warranty Warranty InformationLimited Warranty VENT-FREE GAS Fireplace System

VSGF36NR, VSGF36PR specifications

The Desa VSGF36NR and VSGF36PR are innovative electric fireplaces designed to create a cozy atmosphere while ensuring modern efficiency. These models stand out in the electric fireplace market due to their blend of aesthetic appeal and advanced technology.

One of the key features of the VSGF36NR and VSGF36PR is their realistic flame technology, which provides a lifelike fire experience. The LED flame effect is adjustable, allowing users to customize the ambiance according to their preferences. This feature, combined with a log set that mimics real wood, offers an inviting glow that transforms any space.

Energy efficiency is another significant characteristic of these models. Both fireplaces use energy-efficient LED lights, resulting in lower energy consumption compared to traditional heating methods. Furthermore, they have adjustable heat settings, enabling users to control the amount of warmth emitted, which ultimately helps in managing energy expenditure and ensuring comfort.

The VSGF36NR is designed for natural venting, making it an ideal option for homes that require the integration of a venting system. On the other hand, the VSGF36PR model features a power vent option, providing versatility for installation in various spaces, including basements or rooms without existing venting. This flexibility facilitates installation in a range of environments, creating easy access to the warmth and charm of a fireplace.

Safety is a top priority with these models. They come equipped with an automatic shut-off feature, which activates if the unit overheats, ensuring peace of mind for users. The cool-to-the-touch exterior design further enhances safety, making these electric fireplaces suitable for homes with children and pets.

Both the VSGF36NR and VSGF36PR have a sleek, modern design, allowing them to fit seamlessly into any decor style, from contemporary to traditional. Their compact size means they can easily be integrated into living rooms, dining areas, or even bedrooms, making them a versatile addition.

Overall, the Desa VSGF36NR and VSGF36PR electric fireplaces are exemplary models combining aesthetics, advanced technology, and safety. They offer a practical solution for those looking to enjoy the warmth and comfort of a fireplace without the hassle of traditional wood-burning options. With their innovative features and thoughtful design, they are an excellent choice for enhancing any home.