Desa VSGF36NR, VSGF36PR installation manual Blower Operation, Optional HAND-HELD Remote Operation

Page 22

OPERATING FIREPLACE

Continued

BLOWER OPERATION

WARNING: Make sure the se- lectorswitchisintheOFFposition whenyouareawayfromhomefor long periods of time. Heater will comeonautomaticallywithselec- tor switch in the ON position.

Pilot

Ignitor

Pilot

Ignitor

Burner

Electrode

Electrode

Burner

 

 

Figure 29 - Pilot

Figure 30 - Pilot

(Natural)

(Propane/LP)

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater

1.Turn control knob clockwise to the OFF position.

2a.

Set selector switch in the OFF position.

2b.

If Using Optional Hand-Held Remote: Set

 

selector switch in the OFF position to keep

 

from draining battery.

Shutting Off Burners Only (pilot stays lit)

You may shut off the burners and keep the pilot

lit by doing one of the following:

Turn control knob clockwise to the PILOT position.

Use remote control manual OFF button.

Set selector switch in the OFF position.

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, page 21.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions, page 21.

WARNING: This fireplace has athree-prong,groundedelectrical plug. This plug helps protect you againstelectricalshock.Onlycon- nect plug to a properly grounded, three-prongreceptacle.Donotcut or remove the grounding prong from this plug.

Locate the blower switch by opening lower louver on fireplace. Blower switch is located at lower left inside louver door. Note: It is safe to operate fireplace with blower turned off. However, the blower helps distribute heated air from the fireplace. Note: Periodically check the louvers of the firebox and remove any dust, dirt or other obstructions.

OPTIONAL HAND-HELD

REMOTE OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, pages 31). Follow instructions included with the re- mote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 21.

After lighting, let pilot flame burn for about one minute. Turn control knob to ON posi- tion. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 31, page 23). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit. IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held remote until burner turns on. Hold the control button again until burner turns off (see Figure 32).

22

www.desatech.com

113192-01D

Image 22
Contents What to do if YOU Smell GAS Table of Contents Safety Information Local Codes Product Identification Product FeaturesUnpacking Locating Firebox Product SpecificationsPlanning Unusually Tight Construction AIR for Combustion VentilationProviding Adequate Ventilation Confined and Unconfined SpaceDetermining FRESH-AIR Flow for Heater Location Determining if You Have a Confined or Unconfined SpaceVentilation Air From Inside Building InstallationVentilation AIR Ventilation Air From OutdoorsInstallation Clearances Minimum Wall and Ceiling Clearances see FigureBUILT-IN Firebox Installation Mantel Clearances for Built-In InstallationRough Opening Dimensions for Built-in Installation Installing Firebox Using Optional Accessory Mantels Installing GAS Piping to Fireplace LocationNatural Gas Installation Items NeededPropane/LP Connecting Fireplace to GAS Supply Removing Log Base Assembly From FireplaceTest Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS ConnectionsTest Pressures In Excess Of 1/2 Psig 3.5 kPa Groove HARD-WIRING Firebox Installing Fireplace Hood and ScreenOperating Fireplace Thermostat Models For Your Safety Read Before LightingLighting Instructions To Turn OFF GAS To Appliance Manual Lighting ProcedureRemote Control Models For Your Safety Read Before Lighting Thermostat Control OperationSet flame adjustment knob to any level between HI and LO ON/OFF Series Model Ghrcb Blower OperationOptional HAND-HELD Remote Operation Shutting Off HeaterThermostat Series Model Ghrctb Manual ModeAuto Shutoff Feature TurnsPilot Flame Pattern Key Pad Lock FeatureInspecting Burners Main BurnerCleaning Maintenance Burner Injector Holder and Pilot AIR Inlet HoleTechnical Service Wiring Diagram Replacement PartsSpecifications Service HintsTroubleshooting Observed Problem Possible Cause RemedyDiagram, See Cleaning and Mainte Shut off gas supply Do not try to light any appliance Accessories Illustrated Parts Breakdown Models VSGF36PT, VSGF36NTParts List Models VSGF36PR, VSGF36NR KEY Part Number VSGF36PR VSGF36NR Description QTY Models VSGF36PT, VSGF36NT, VSGF36PR and VSGF36NR KEY Part Number Description QTY 113192-01D 113192-01D Keep this Warranty Warranty InformationLimited Warranty VENT-FREE GAS Fireplace System

VSGF36NR, VSGF36PR specifications

The Desa VSGF36NR and VSGF36PR are innovative electric fireplaces designed to create a cozy atmosphere while ensuring modern efficiency. These models stand out in the electric fireplace market due to their blend of aesthetic appeal and advanced technology.

One of the key features of the VSGF36NR and VSGF36PR is their realistic flame technology, which provides a lifelike fire experience. The LED flame effect is adjustable, allowing users to customize the ambiance according to their preferences. This feature, combined with a log set that mimics real wood, offers an inviting glow that transforms any space.

Energy efficiency is another significant characteristic of these models. Both fireplaces use energy-efficient LED lights, resulting in lower energy consumption compared to traditional heating methods. Furthermore, they have adjustable heat settings, enabling users to control the amount of warmth emitted, which ultimately helps in managing energy expenditure and ensuring comfort.

The VSGF36NR is designed for natural venting, making it an ideal option for homes that require the integration of a venting system. On the other hand, the VSGF36PR model features a power vent option, providing versatility for installation in various spaces, including basements or rooms without existing venting. This flexibility facilitates installation in a range of environments, creating easy access to the warmth and charm of a fireplace.

Safety is a top priority with these models. They come equipped with an automatic shut-off feature, which activates if the unit overheats, ensuring peace of mind for users. The cool-to-the-touch exterior design further enhances safety, making these electric fireplaces suitable for homes with children and pets.

Both the VSGF36NR and VSGF36PR have a sleek, modern design, allowing them to fit seamlessly into any decor style, from contemporary to traditional. Their compact size means they can easily be integrated into living rooms, dining areas, or even bedrooms, making them a versatile addition.

Overall, the Desa VSGF36NR and VSGF36PR electric fireplaces are exemplary models combining aesthetics, advanced technology, and safety. They offer a practical solution for those looking to enjoy the warmth and comfort of a fireplace without the hassle of traditional wood-burning options. With their innovative features and thoughtful design, they are an excellent choice for enhancing any home.