Desa VMH26TNC, VMH26TPC installation manual Rough Opening for Installing Wall

Page 11

INSTALLATION

Continued

WARNING: If pre-wiring, do not connect wiring to any elec- trical source at this time.

Install fireplace electrical outlet and connect wiring to outlet be- fore connecting to electrical source. The fireplace electrical outlet is included with the GA3450T blower accessory.

Only use the fireplace electrical outlet supplied with the GA3450T blower accessory.

2.If installing GA3450T blower accessory, do so at this time. See Installing Blower Acces- sory GA3450T, page 13.

Note: If not installing blower accessory, you may wish to run electrical wiring to your fire- place for future blower installation (see Ac- cessories, page 30) Use only approved three- wire electrical wiring.

Note: A qualified installer should make all electrical connections.

3.Install gas piping to fireplace location. This installation includes an approved flexible gas line (if allowed by local codes) after the equip- ment shutoff valve. The flexible gas line must be the last item installed on the gas piping.

4.If you have not assembled firebox, follow in- structions on page 4.

5.Carefully set fireplace in front of rough open- ing with back of fireplace inside wall opening.

6.Attach flexible gas line to fireplace gas regu- lator. See Connecting to Gas Supply, page 16.

7.Bend four nailing flanges on outer casing with pliers (see Figure 10).

8.Attach fireplace to wall studs using nails or wood screws through holes in nailing flange.

9.Check all gas connections for leaks. See Checking Gas Connections, page 18.

10.If using optional trim kit, install the trim after final finishing and/or painting of wall. See in- structions included with trim accessory for at- taching trim.

IMPORTANT: When finishing your firebox, com- bustible materials

WARNING: Do not allow any combustible materials to over- lap the firebox front facing.

IMPORTANT: Noncombustible materials such as brick, tile, etc. may overlap the front facing, but should never cover any necessary openings like louvered slots.

WARNING: Do not allow non- combustible materials to cover any necessary openings like lou- vered slots.

101/2"

267/8"

3/4" Off

The Floor

267/8" Minimum

Figure 8 - Rough Opening for Installing

in Wall

365/8"

257/8"

267/8" 513/4"

Figure 9 - Rough Opening for Installing

in Corner

Nails or

Wood

Screws

Nailing

Flanges

Figure 10 - Attaching Fireplace to Wall

Studs

113111-01B

www.desatech.com

11

Image 11
Contents What to do if YOU Smell GAS Shown with Optional Cabinet Mantel/Hearth Base AccessoryTable of Contents Safety Information Product Identification Local CodesUnpacking Product FeaturesAssembly Unusually Tight Construction AIR for Combustion VentilationProviding Adequate Ventilation Assembling HoodDetermining if You Have a Confined or Unconfined Space Determining FRESH-AIR Flow for Fireplace LocationConfined and Unconfined Space Ventilation Air From Outdoors Ventilation AIRVentilation Air From Inside Building Check GAS Type InstallationInstallation Items Locating Fireplace BUILT-IN Fireplace InstallationRough Opening for Installing Wall Mantel Clearances for Built-In Installation Optional Mantel InstallationRemoving Valve Cover Shield Installing Blower Accessory GA3450TRemoving Upper Louver Assembly Assembling Perimeter Trim Trim Shipped with MantelRemoving Valve Cover Shield Installing Blower AssemblyFor Built-In Installation Installing Switch Plate to Valve Cover ShieldExtension Cord Connecting to GAS SupplyAttaching Wood Base to Solid Floor Installation Items Needed Connecting Equipment Shutoff Valve to Heater ControlChecking GAS Connections Pressure Testing Gas Supply Piping SystemPressure Testing Fireplace Gas Connections Lighting Instructions For Your Safety Read Before LightingOperating Fireplace Shutting Off Fireplace Manual Lighting ProcedureTo Turn OFF GAS To Appliance Thermostat Control OperationPilot Flame Pattern Inspecting BurnerOperating Blower Burner Flame PatternAir Passageways Cleaning MaintenanceBurner Injector Holder and Pilot AIR Inlet Hole CabinetObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Residues from manufacturing Statement above Gas leak. See WarningReplacement Parts SpecificationsService Hints Technical ServiceIllustrated Parts Breakdown Parts List Accessories Information Video Cleaning KIT GCKCorner Mantel with Full Hearth Base Cabinet Mantel and Full Hearth BaseLimited Warranty VENT-FREE Compact Classic Hearth Fireplace Warranty InformationKeep this Warranty