Auto Function Selection

•If you press PLAY/PAUSE (B/[]) on the remote control during radio receiving, CD will operate automatically.

•If you press PRESET ( / ) on the remote control during CD, radio function will operate.

Setting the Clock

1.Press CLOCK.

(If the clock requires setting, press and hold CLOCK for more than 2 seconds.)

2.Select a 24 hour cycle or 12 hour cycle by pressing . bb/BB > on the front panel.

(12HR) or (24HR)

3.Press SET/CD[] to confirm the selected hour cycle.

4.Use . bb/BB > on the front panel to set the correct hours.

5.Press SET/CD[].

6.Use . bb/BB > on the front panel to set the correct minutes.

7.Press SET/CD[] and the correct time is shown on the display.

8.Press CLOCK at any time to display the time for about 5 seconds.

Using the Sleep Function

When the sleep timer is used, the power is auto- matically turned off after the specified time has elapsed.

1.To specify the time delay before the power is turned off, press SLEEP.

In the display window you see for about 5 seconds. This means that the system turns off automatically after 90 minutes.

Press SLEEP until the desired time is dis- played.

Note: Each time the button is pressed the time interval is reduced by 10 minutes. i.e. 80...70... etc.

2.To check the remaining time until the power is turned off, press SLEEP while the sleep function is active. The time remaining is dis- played for about 5 seconds.

ote

If you press SLEEP while the sleep time is displayed, the SLEEP time is reset.

3.To cancel the sleep timer mode, press the SLEEP button repeatedly until “SLEEP 10” appears, and then press SLEEP once again while “SLEEP 10” indicator is displayed.