Empire Comfort Systems 31)L(N, VFP36FP, VFP32FP, P)-1, 21)L(N VFP32,36FP30,31 Lighting Instructions

VFP(32,36)FP(30,31) LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance areaforgas.Besuretosmellnexttothefloorbecausesome gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electrical switch;

Do not use any phone in your building.

•Immediately call yourgas supplierfrom a neighbor's phone. Follow the gas supplier's instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.	STOP! Read the safety information label.			8.	Turn gas control knob counterclockwise	to "PI-
2.	Set REMOTE/OFF/ON switch to "OFF."				LOT."
3.	Turn off all electric power to the			9.	Push in control knob all the way and hold in. Repeatedly
	appliance (if applicable).				push the Piezo Ignitor Button until the pilot is lit. Continue
4.	Open bottom louver assembly.				to hold the control knob in for about one (1) minute after
5.	Push in gas control knob slightly and				the pilot is lit. Release knob, and it will pop back up. Pilot
	turn clockwise	to "OFF."	GAS CONTROL KNOB		should remain lit. If it goes out, repeat steps 5 through 9.
	NOTE: Knob cannot be turned from		SHOWN IN "OFF" POSITION.	•	If knob does not pop up when released, STOP and IM-
	"PILOT" to "OFF" unless knob is				MEDIATELY call a qualified service technician or gas
	pushed in slightly. Do not force.		REMOTE		supplier.
6.	Wait ten (10) minutes to clear out any gas.		OFF	•	If the pilot will not stay lit after several tries, turn the gas
			ON
	Then smell for gas, including near the floor. If				control knob to "OFF" and call your service technician or
	you smell gas, STOP! Follow "B"		PILOT		gas supplier.
	in the safety information above. If		THERMOPILE	10.	Turn gas control knob counterclockwise	to
			ELECTRODE
	you do not smell gas, go to the next				"ON."
	step.			11.	Close bottom louver assembly.
7.	Find pilot - Follow metal tube			12.	Turn on all electric power to the appliance (if appli-
	from gas control. The pilot is THERMOCOUPLE				cable).
	behind the burner on the right (LPG)		THERMOCOUPLE	13.	Set REMOTE/OFF/ON switch to desired setting.
	side.		(NATURAL)

TO TURN OFF GAS TO APPLIANCE

1.Set REMOTE/OFF/ON switch to "OFF."

2.Turn off all electric power to the appliance if service is to be performed (if applicable).

3.Open bottom louver assembly.

4.Push in gas control knob slightly and turn clockwise to "OFF." Do not force.

5.Close bottom louver assembly.

20101-0-0306 Page 17