Enviro EF3 owner manual Outside Vertical Installation

Page 23

Installation

 

Rain cap

 

Flashing

 

24"

 

(61 cm)

 

3" (7.5 cm)

 

Clearance

 

2"

 

(5 cm)

 

Support

 

bracket

 

Tee with

 

cleanout

6"

Type "L"

(15 cm)

vent

 

Fresh air

 

intake

Non-combustible

Existing floor

floor protection.

(combustible)

Figure 28: Outside Vertical Installation.

HEARTH MOUNT INSTALLATION - FREESTANDING:

��������� ���

��������� ������

������ ���� ����

�������� �� �����

������� ������ ������

��������� ��� ��

������������ ����

����������� ��

������� ��� �����

������ �������

�� �������� ����

��� ����� ��� ������

������� �� ��� ���

���� ��� �� �����

 

��� ��

 

���� ���

 

����� ����������

������� ���������

����������� �����

Refer to Figures 29 and 30.

1.Install the hearth pad.

2.Lock fireplace damper in the open position.

3.Install a positive flue connector at the fireplace dampers.

4.Connect a tee or a 90° elbow to the exhaust pipe.

5.Install flexible stainless steel liner or listed pellet vent to the top of the chimney.

Figure 29: Freestanding hearth mount installation.

23

Image 23
Contents EF3 Table of Contents Store pellets at least 36 1 m away from the pellet stove IntroductionI. Pellet Standards USE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Special Notes Reasons WHY the Unit OverheatedOperating Instructions Seconds on Initial START-UP See above Thermostat / Switch ModeDial-A-Fire control panel StoveInside Firebox weekly Routine Cleaning and MaintenanceTools Required to Clean Unit Burn POT and Liner 2-3 daysFresh AIR Intake season Removal of the firebox backing for bi-annual cleaningFreestanding ASH PAN Heat Exchanger Tubes 2-3 daysBrick Panel Post Season CLEAN-UPCleaning Plated Surfaces Screws to take out to remove stove from pallet InstallationDimensions of EF3 Freestanding Minimum Alcove width Inches 91 cm Minimum Alcove height EF3 Built-In Heater recommended Framing Or from the outside of the pedestal for the FPI or BIHVent surfaces can Install Vent AT Clearances Specified by Venting Manufacturer Fresh Air Intake Place the appliance 15 37.5 cm Is the recommended installation set up Inside Vertical Installation Outside Vertical Installation Freestanding hearth mount installation overview Connect a tee or 90 degree This unit includes a 3 75 mm pedestal Corner Brackets Side surround panel swings forward RemovalStove will not start. General TroubleshootingDo not What to do ifConvection blower will not function normally. General Stove will not operate when hot. GeneralExhaust motor will not function normally. General Auger motor will not function normally. General Potentiometer Readings Dial-a-fire has no effect on the fire Timer Control Only200F 93C high limit temperature sensor has tripped Stove keeps going out Stove will not shut off. GeneralFuses Wiring Diagram Timer Control Wiring DiagramReference Description Part Number Parts ListParts List Options ComponentsDiagramParts Parts Diagram Steel For the do-it-yourself Individual WarrantyTo the Distributor Name of Owner Address Installation Data Sheet
Related manuals
Manual 38 pages 19.67 Kb

EF3 specifications

The Enviro EF3 is an innovative and eco-friendly vehicle that is transforming the landscape of sustainable transportation. With a focus on efficiency, performance, and environmental responsibility, the EF3 represents a significant leap forward in automotive technology.

One of the standout features of the Enviro EF3 is its advanced electric powertrain. This vehicle is equipped with a state-of-the-art electric motor that provides impressive torque and acceleration while remaining silent and efficient. The electric motor is powered by a high-capacity lithium-ion battery pack, which can be charged quickly and has a long lifespan. This allows for extended driving ranges, making the EF3 ideal for both urban commuting and longer journeys.

The EF3 also incorporates regenerative braking technology, which captures energy that would otherwise be lost during braking. This innovative feature helps to recharge the battery while enhancing overall energy efficiency. As a result, drivers can enjoy longer trips and reduced charging frequency, while also minimizing the vehicle's overall environmental impact.

In terms of design, the Enviro EF3 boasts a sleek, aerodynamic profile that not only looks modern but also contributes to its overall efficiency. The vehicle's exterior is crafted using lightweight materials, which enhance performance and help to maximize range. Additionally, the spacious interior is designed with comfort and sustainability in mind. Eco-friendly materials are used throughout the cabin, ensuring that the EF3 remains a green choice even inside the vehicle.

Connectivity is another vital characteristic of the Enviro EF3. Equipped with the latest infotainment and navigation technologies, the vehicle offers seamless integration with smartphones and other devices. This feature allows drivers to access real-time traffic updates, manage charging schedules, and even control various vehicle settings from their mobile devices.

Safety is prioritized in the design of the EF3, with advanced driver-assistance systems (ADAS) that include features such as adaptive cruise control, lane-keeping assist, and collision avoidance technology. These systems work together to enhance driver confidence and ensure a safe driving experience.

In conclusion, the Enviro EF3 represents the future of sustainable transportation. With its electric powertrain, advanced technologies, aerodynamic design, and a strong focus on safety and connectivity, the EF3 is a versatile and eco-friendly vehicle that meets the demands of modern drivers while contributing to a healthier planet. As more consumers seek environmentally responsible choices, the Enviro EF3 stands out as a leading option in the electric vehicle market.